Stimmen - 5, Durchschnittliche Bewertung: 3.8 ( )

Hersteller: Shoprider Dateigröße: 547.87 kb Dateiname: Unterrichtssprache:

• It is highly recommended that the batteries be fully charged after each use. If the batteries are weak, severely discharged or old, a variety of problems may occur with the unit including charging problems, reduced speed, loss of range, loss of charge capacity and others. Please contact your provider for battery replacement and proper disposal. 4/27/2006 18 Batteries & Battery ChargingBatteries Shoprider HD, Shoprider WS The Shoprider WS is designed to operate on two 12 volt/36Ah sealed lead acid (AGM or gel-cell type) aka SLA maintenance free batteries. While the Shoprider HD is designed to operate on two 12 volt/75Ah sealed lead acid (AGM or gel-cell type) aka SLA maintenance free batteries. The life of the batteries may be affected by temperature, terrain, weight of user, driving methods, and care of batteries. It is recommended that you charge your batteries after every use. Please pay close attention to the light indication on the charger to ensure that the batteries are fully charged before taken off of the charger. The active user will need to charge the batteries after using approximately 30% of battery capacity. As an inactive user, only using from once a week to every other day, the recharge point would be at 50% of discharge (Refer to Figure 8). For extended battery life, it is highly recommended that these guidelines be followed. You cannot over charge the batteries. *Keeping the batteries charged extends the life of the batteries* SLA batteries should be kept fully charged at all times. They must not be left in a discharged state if the unit is not being used for some time or the batteries will be permanently damaged and will no longer hold a charge. The SLA batteries should be checked once a month and kept charged as needed. Typically SLA batteries have up to about 400 charging cycles. Red Bottom Amber Middle Green Top3 Bars 4 Bars 3 Bars Flashing. Danger, you must From 30% 50% Full battery charge. stop and recharge the discharge. Batteries batteries. Failure to do so will may result in damage of need charging. batteries. NEVER DISCHARGE BATTERIES TO RED BARS OF INDICATOR! Figure 14 4/27/2006 19 Battery Charging Procedure Charging the Shoprider portable Powerchair: Shoprider HD & WS 1) Plug the A/C power cord into the wall. Plug the male three-pin charger plug into the female 3-pin receiver located on the bottom of the VSI/VR2 (Refer to Figure 3, #8 & Fig. 4, #8). The battery charger’s light indicator is as follows: Red -Charging Amber-Charging Green -Charging complete Depending on the amount of battery discharge, the charge time can take up to 12 hours. The battery charger has an electronic switch that will terminate the charge when the batteries are fully charged. Do not remove the battery charger until the charging cycle is complete. Be sure to unplug charger from the wall first before unplugging charger from the Powerchair. WARNING! Only use the original manufacturer approved charger! This charger is for indoor use only. Do not expose it to rain or water spray. Do not leave the charger plugged into the Charging Port if the charger is not charging. 4/27/2006 20 Troubleshooting The Self-Help Guide (Table 1) is intended to assist in the location of a fault that may occur in a certain part of the Powerchair. If after checking the fault from the table below and the fault is still showing, do not use the Powerchair. Turn off the power and consult your provider immediately. Table 1 BATTERY GAUGE FAULT CODE POSSIBLE VSI-50/VR2 FAULT 10 Bars flash Battery voltage is too high, check the battery connections. Call your Shoprider Provider 9 Bars flash Solenoid brake fault. Check drive/freewheel levers. 8 Bars flash Possible controller fault. Check controller connector. Call your Shoprider Provider. 7 Bars flash Possible joystick fault. Be sure joystick is at center when controller is turned on. Call your Shoprider Provider. 6 Bars flash Battery charger connected. Unplug charger. 5 Bars flash Right-hand motor wiring fault. Check connections. Call your Shoprider Provider. 4 Bars flash Right-hand motor disconnected. Check connections. Call your Shoprider Provider. 3 Bars flash Left-hand motor wiring fault. Check connections. Call your Shoprider Provider. 2 Bars flash Left-hand motor disconnected. Check connections. Call your Shoprider Provider. 1 Bar flash Low battery voltage. Charge batteries immediately. Do not drive Powerchair until batteries are completely charged! Battery/ Charging Troubleshooting Shoprider WS & HD– If the charger indicator light has a blinking red light after being plugged in and doesn’t charge the batteries the batteries may be over discharged or there may be a brake in the connection (loose wires or connections) and may require additional service or replacement. Contact your provider for assistance. If the charger indicator light goes immediately to green when plugged in to charge, the problem is likely a blown fuse popped circuit breaker (push reset button) or similar. Contact ...

Herunterladen

Geben Sie zwei Ziffern: