Stimmen - 3, Durchschnittliche Bewertung: 4 ( )

Hersteller: Shoprider Dateigröße: 513.45 kb Dateiname: Unterrichtssprache:

• Mount the scooter, either by lifting the arm and sliding on to the seat or rotate the seat outwards and then rotate the seat back to face the tiller. • Adjust the tiller and seat as described previously. Starting Scooter Movement • Ensure that you are seated in a comfortable position. • Turn the key to the ON position. 5/11/2004 10 • Your speed setting should be on 1 or 2. • Pull your right hand finger lever, the scooter will move forward slowly. The harder you pull the faster the scooter goes but will only reach the speed level that has been selected. • Release the lever and the scooter will slowly come to a stop and the magnetic brake will be applied. Steering Steering the scooter is light and easy. Ensure when starting off you give a wide clearance when turning so that the rear wheels clear any obstacle that you are passing. When steering through limited spaces such as a doorway or when turning around, turn the tiller handles where you want to go and apply power gently. The scooter will turn very tightly, but will still move with complete stability as long as the speed is not too high. Reversing Before reversing ensure that the area behind is free from any hazards or obstructions. Adjust your speed setting to a low setting before you reverse. Pull/press the left thumb/finger lever, and steer wide of all corners and obstacles. Dismounting Before dismounting ensure that the key is turned to the off position. CAUTION: Please ensure that care is exercised when entering or leaving the scooter and that the tiller and foot rest is not used for support. EXTRA GUIDELINES IN THE CONTROL OF YOUR SCOOTER Ramps The stability of your scooter is governed by several factors such as the seating position, the angle of the slope and your height and weight. When approaching an incline, do so directly and not at an angle and whenever possible avoid making turns. When going down a ramp or slope keep the speed settings to slow. This will ensure there is a safe controlled descent. When the finger levers are released the scooter will slowly stop. Caution - Do not turn off the control key while the unit is in motion Grass and Gravel Please follow the guidelines given previously and your scooter will perform admirably over many surfaces. Avoid long grass, loose gravel and sand. NOTE: You should not operate your scooter in wet weather or on wet surfaces. This may cause the motor to sort out. 5/11/2004 11 TRANSPORT / STORAGE The scooters are designed to be dismantled into separate sections for transportation and storage. Your scooter can be dismantled into the following sections: Sunrunner™ 3 (Fig. 13) 1) Basket 2) Deluxe Captain Seat 3) Seat Post & Fasteners 4) Driving Unit Sunrunner™ 4 (Fig. 14) 1) Basket 2) Deluxe Captain Seat 3) Seat Post & Fasteners 4) Driving Unit Sunrunner™ 3 Deluxe (Fig. 15) 1) Basket 2) Black Leatherette Pillow Top Seat 3) Seat Post & Fasteners 4) Driving Unit Figure 13 Figure 14 Figure 15 Figure 16 2 3 1 4 4 1 2 3 4 1 3 2 4 2 1 3 Sunrunner™ 4 Deluxe (Fig. 16) 1) Basket 2) Black Leatherette Pillow Top Seat 3) Seat Post 4) Driving Unit Dismantling 1. Remove baskets. 2. Fold down the back of the seat. 5/11/2004 12 3. Pull up on the red lever under the seat and at the same time lift and twist the seat off. 4. Unscrew tightening bolt and remove seat post. BATTERIES AND BATTERY CHARGER The Shoprider® scooter is supplied with maintenance free, sealed lead acid batteries. Battery performance can be affected by temperature, terrain, condition of battery, the weight of the user, etc. The battery level indicator is only a guide and is most effective when the scooter is moving, only then is the true discharge level displayed. • When the scooter stops the battery level indicator may indicate full. • An active user can use up to 30% of battery capacity or more per day. • Inactive users may only use 50% of battery capacity in a week. • In both these instances the battery should be put on charge over night. Battery Charger Batteries supplied with your scooter are specially designed. All the units require an automatic battery charger. These chargers have an electronic switch that will terminate the charge when the batteries are fully charged. The battery chargers for the Sunrunner™ 3 and Sunrunner™ 4 are 3-amp transformer type off board chargers. The battery chargers for the Sunrunner™ 3 Deluxe and Sunrunner™ 4 Deluxe are 4-amp transformer type on board chargers. Charging To charge the batteries connect the plug lead into the battery-charging socket on the scooter/battery pack and the 3-prong plug into the wall socket and switch on. FOR Sunrunner™ 3 and Sunrunner™ 4 ONLY: the battery charger has two lights. The red light when constant shows the battery charger is connected if the red light flashes; there is a break in the connection. The green light flashes when the batteries are receiving charge and is constant when the charge is complete. FOR Sunrunner™ 3 Deluxe and Sunrunner™ 4 Deluxe ONLY: Next to the charger is an L...

Herunterladen

Geben Sie zwei Ziffern: