Improper use of heater can cause serious injury. Keep this manual for future reference. CONTENTS SECTION_PAGE Safety Information.........................................................................3 Product Identification....................................................................4 Unpacking......................................................................................4 Theory of Operation......................................................................5 Propane Su

11. Do not use heater if any part has been under water. Immediately call a qualified service technician to inspect the room heater and to replace any part of the control system and any gas control which has been under water. 12. Turn off heater and let cool before servicing. Only a qualified service person should service and repair heater. 13. Operating heater above elevations of 4,500 feet could cause pilot outage. 14. To prevent performance problems, do not use propane/LP fuel tank of less tha

Never place any objects on the heater. 11. Surface of heater becomes very hot when running heater. Keep children and adults away from hot surface to avoid burns or clothing ignition. Heater will remain hot for a time after shut-down. Allow surface to cool before touching. 12. Carefully supervise young children when they are in same room with heater. 13. Make sure grill guard is in place before running heater. 14. Do not use heater if any part has been under water. Immediately call a quali- fied

Continue holding down control knob. Repeat igniting operation until air is removed 4. Clean ODS/pilot (see Cleaning and Maintenance, page 22) or replace ODS/pilot assembly 5. Replace gas regulator 1. Press in control knob fully 2. After ODS/pilot lights, keep control knob pressed in 10 seconds 3. Fully open manual shut-off valve 4. Hand tighten until snug, then tighten 1/4 turn more 5. A) Contact local natural gas company B) Clean ODS/pilot (see Cleaning and Maintenance, page 22) or replace ODS/

• Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions. • If you cannot reach your gas supplier, call the fire department. POSSIBLE CAUSE REMEDY 1. This is common with most heaters. If Heater produces a clicking/ticking noise 1. Metal expanding while heating or con- noise is excessive, contact qualified ser just after burner is lit or shut off tracting while cooling vice person Heater produces unwanted odors 1. Heater burning vapors from paint, sol-1

Provides better heat distribution. Makes heater more efficient. Complete installation and operating instructions included. Manually controlled - GA3100A. Includes ON/OFF switch. Thermostatically controlled - GA3200TA. Includes three settings: ON/OFF/AUTO. RN30D CGN20(L) 15,000/30,000 10,000/20,000 Natural Only Natural Only Piezo Piezo 3" W.C. 3" W.C. 10.5" 10.5" 4" 4" 23.5 x 25.9 x 8.0 23.5 x 18.5 x 8.0 26 x 27.75 x 9.63 26 x 20.5 x 9.63 30 22 35 27 FLOOR MOUNTING STAND 20,000 Btu/Hr Models CGN2

Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water. LIGHTING INSTRUCTIONS 1. STOP! Read the safety information above. 2. Make sure manual shutoff valve is fully open. 3. Turn control knob clockwise to the OFF position. Control Knob OFF HIGH PILOTLOW IGNITOR Ignitor Button Figure 16 - Control Knob In The OFF Position Continued 100098 17 OPERATING HEATER Continued 4. Wait five (5) min

They have agreed to support our customer’s needs by providing original replacement parts and accessories. When calling a Parts Central, ask for the Parts Department. Baltimore Electric 1348 Dixwell Avenue Hamden, CT 06514 1-800-397-7553 203-248-7553 Parts Department Portable Heater Parts 342 N. County Rd. 400 East Valparaiso, IN 46383 All States 219-462-7441 1-800-362-6951 Parts Department FBD 1349 Adams Street Bowling Green, KY 42103 502-846-1199 1-800-654-8534 Fax: 1-800-846-0090 Four Flags Po

To light pilot with match, see Manual Lighting Procedure, page 11. Ignitor Electrode Thermocouple Pilot Burner Figure 17 - Pilot Pilot 7. Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Note: If pilot goes out, repeat steps 3 through 7. Continued 10 103569 OWNER’S MANUAL OPERATING HEATER Continued 8. Turn control knob counterclockwise to the LOW position. The main burner should light. Set control knob to any heat level between HIGH and LO

Keep control knob pressed in for 10 seconds after lighting pilot. After 10 seconds, release control knob. • If control knob does not pop up when released, contact a qualified service person or gas supplier for repairs. Note: If pilot goes out, repeat steps 3 through 7. 18 OPERATING HEATER Continued TO SELECT HEATING LEVEL WARNING When running heater, set control knob at LOW, MEDIUM, or HIGH locked positions. Never set control knob between locked positions. Poor combustion may result. CAUTION Do