Stimmen - 2, Durchschnittliche Bewertung: 4 ( )

Hersteller: Empire Comfort Systems Dateigröße: 422.53 kb Dateiname: Unterrichtssprache:

GENERAL INFORMATION Qualified Installing Agency Installation and replacement of gas piping, gas utilization equipment or accessories and repair and servicing of equipment shall be performed only by a qualified agency. The term "qualified agency" means any individual, firm, corporation, or company that either in person or through a representative is engaged in and is responsible for (a) the installation, testing, or replacement of gas piping or (b) the connection, installation, testing, repair, or servicing of equipment; that is experienced in such work; that is familiar with all precautions required, and that has complied with all the requirements of the authority having jurisdiction. The installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/ NFPA54.* *Available from the American National Standards Institute, Inc. 11 West 42nd St., New York, N.Y. 10018. State of Massachusetts: The installation must be made by a licensed plumber or gas fitter in the Commonwealth of Massachusetts. In the Commonwealth of Massachusetts vent free products are not approved. State of Massachusetts requirement for installation of vented decorative appliance in a vented fireplace is the following: A vented decorative gas appliance must be installed in a vented fireplace only in the state of Massachusetts. The vent damper must be removed or welded permanently open. 15997-0-0903 Page 3 LOG PLACEMENT LOG PLACEMENT Before you begin: Do not, handle these logs with your bare hands! Always wear gloves to prevent skin irritation. After handling logs, wash your hands gently with soap and water. All Logs The positioning of the logs is critical to the safe and clean operation of this heater. Sooting and other problems may result if the logs are not properly and firmly positioned in the appliance. Refer to Figure 1 for the following warning. Warning: Failure to position the parts in accordance with this diagram or failure to use only parts specifically approved with this appliance may result in property damage or personal injury. PROPER INSTALLATION SEQUENCE: LS-(18, 24, 30)FA(C,O,S) (Figure 1) 1. Place back left (#1) log onto left, rear pin on rear log support. 2. Place back right (#2) log onto right, rear pin on rear log support. 3. Place front left (#3) log onto two (2) left, front pins on burner pan. 4. Place front right (#4) log onto two (2) right, front pins on burner pan. 5. Place front (#5) log in front of burner pan. 6. Compare the completed log installation with the appropriate photo from pages 5 through 7. Review previous steps to make any necessary adjustments. 7. Log placement is completed. Apply loose material (glowing embers) per appropriate Installation Instructions and Owner's Manual. Replacement of loose material (glowing embers) must be purchased from Empire Comfort Systems, Inc. Application of excess loose material (glowing embers) may adversely affect performance of the heater. WARNING: All prev...

Herunterladen

Geben Sie zwei Ziffern: