Stimmen - 4, Durchschnittliche Bewertung: 3.8 ( )

Hersteller: Nilfisk-Advance America Dateigröße: 2.41 mb Dateiname: Unterrichtssprache:

Do not lower the blades too much to where they fold over excessively and cause unneeded blade wear. FIGURE 5 A-16 - 56041647 - Adhancer™ R28-C, R32-C / BR 800S TRIO EDS™ revised 2/07 ENGLISH / A-17 GENERAL MACHINE TROUBLESHOOTING Problem Possible Cause Remedy Poor water pick-up Worn or torn squeegee blades Reverse or replace Squeegee out of adjustment Adjust so blades touch floor evenly across entire width Recovery tank full Empty recovery tank Recovery tank drain hose leak Secure drain hose cap or replace Recovery tank cover gasket leak Replace gasket / Seat cover properly Debris caught in squeegee Clean squeegee tool Vacuum hose clogged Remove debris Using too much solution Adjust solution control valves Foam filter cover not seated Seat cover properly Poor scrubbing performance Worn brush Rotate or replace brushes Wrong brush type Consult Nilfisk-Advance Wrong cleaning chemical Consult Nilfisk-Advance Moving machine too fast Slow down Not using enough solution Adjust solution flow rate to high flow Inadequate solution flow or no solution Solution tank empty Fill solution tank Solution lines, valves, filter or trough clogged Flush lines, trough and clean solution filter Solution valve not open Open solution valve Solution solenoid valve Clean or replace valve Machine does not run Emergency stop switch tripped Reconnect battery connectors Operator seat safety switch Check for open circuit and replace Main system controller Check error fault codes (see service manual) Tripped 10 Amp circuit breaker Check for electrical short circuit & reset No FWD/REV wheel drive Drive system speed controller Check error fault codes (see service manual) Tripped 45 Amp circuit breaker Check for drive motor overload Emergency stop switch tripped Reconnect battery connectors Vacuum shuts off and display shows “FULL” when recovery tank is not full Plugged squeegee hose Clear debris Vacuuming large amounts of water at a high travel speed Slow down or disable auto shut-off feature (see service manual) Poor Sweeping Performance Hopper Full Empty and clean hopper Brushes worn Replace brushes Bristles have taken a set Rotate brushes No Detergent Flow Empty detergent cartridge Fill detergent cartridge Plugged or kinked detergent flow line Purge system, straighten lines to remove any kinks Dry seal cap on detergent cartridge not sealed Reseat dry seal cap Detergent pump wiring disconnected or backwards Connect or reconnect wiring Adhancer™ R28-C, R32-C / BR 800S TRIO EDS™ - 56041647 - A-17 A-18 / ENGLISH TECHNICAL SPECIFICATIONS (as installed and tested on the unit) Model Adhancer™ R28-C Adhancer™ R32-C BR 800S TRIO EDS™ Model No. 56316025 56316026 56316038 Voltage, Batteries V 36V 36V 36V Battery Capacity Ah 305 305 305 Protection Grade IEC 65 IPX3 IPX3 IPX3 Sound Pressure Level LpA ISO 11201 dB(A)/20|jPa 77.8 77.8 77.8 Sound Pressure Uncertainty KpA ISO 11201 dB(A)/20|jPa 2.5 2.5 2.5 Sound Power Level LwA ISO 3744 dB(A)/20jPa 85.7 85.7 85.7 Sound Power Uncertainty KwA ISO 3744 dB(A)/20jPa 2.5 2.5 2.5 Gross Weight lbs / kg 1,385 / 628 1,390 / 630 1,390 / 630 Vibrations at the Hand Controls ISO 5349-1 m/s2 1.03m/s2 1.03m/s2 1.03m/s2 Vibrations at the Seat ISO 2631-1 m/s2 0.24m/s2 0.24m/s2 0.24m/s2 Gradeability Transport 14% (8°) 14% (8°) 14% (8°) Cleaning 10% (6°) 10% (6°) 10% (6°) Maximum Wheel Floor loading AACEM PSI / Mpa 129 / 0.89 129 / 0.89 129 / 0.89 A-18 - 56041647 - Adhancer™ R28-C, R32-C / BR 800S TRIO EDS™ B-2 / ESPAÑOL ÍNDICE página Introducción..........................................................................................B-2 Precauciones y advertencias................................................................B-3 Conozca su máquina............................................................................B-4 Panel de control....................................................................................B-5 Preparación de la máquina para el uso Instalación de las baterías....................................................................B-6 Instalación de los cepillos.....................................................................B-7 Instalación de la boquilla......................................................................B-8 Llenado del depósito de solución.........................................................B-8 Sistema de detergente..............................................................B-9 - B-10 Funcionamiento de la máquina..........................................................B-11 Fregado..............................................................................................B-11 Aspiración en húmedo........................................................................B-11 Después de la utilización....................................................................B-12 Programa de mantenimiento.............................

Herunterladen

Geben Sie zwei Ziffern: