Stimmen - 2, Durchschnittliche Bewertung: 4.5
(
)
)
|
Anleitung Zusammenfassung
Before operating the unit, operators shall have read and be familiar with the operator’s manual for the particular unit being operated and they shall also abide by the safety rules and practices in the following paragraphs. Before operating any unit, the operator shall be familiar with unusual operating conditions which may require additional safety precautions or special operating instructions. General Before operating make sure the unit is in the operating position. Do not start or operate the unit, any of its functions or attachments, from any place other than from the designated operators position. Before leaving the operator’s position: A bring the unit to a complete stop; B if the unit must be on an incline, block the wheels. Maintain a safe distance from the edge of ramps, platforms, and other similar working surfaces. Do not add to, or modify the unit. Do not block access to fire aisles, stairways or fire equipment. Traveling Yield the right of way to pedestrians and emergency vehicles such as ambulances and fire trucks. Cross railroad tracks at an angle wherever possible. Do not park closer than 6 ft (1800 mm) to the nearest rail of a railroad track. Keep a clear view of the path of travel and observe for other traffic, personnel, and safe clearances. Under all travel conditions, operate the unit at a speed that will pernit it to be brought to a stop in a safe manner. Do not indulge in stunt driving or horseplay. Slow down for wet and slippery floors. Before driving over a dockboard or bridge plate, be sure that it is properly secured. Drive carefully and slowly across the dockboard or bridge plate, and never exceed its rated capacity. When negotiating turns, reduce speed to a safe level consistent with the operating environment. Make the turns smoothly. Operator care of the unit If the unit is found to be in need of repair or in any way unsafe, or contributes to an unsafe condition, the matter shall be reported immediately to the user’s designated authority, and the unit shall not be operated until it has been restored to safe operating condition. If during operation the unit becomes unsafe in any way, the matter shall be reported immediately to the user’s designated authority, and the unit shall not be operated until it has been restored to safe operating condition. Do not make repairs or adjustments unless specifically authorized to do so. MAINTENANCE AND REBUILD PRACTICES Operation of the unit may be hazardous if maintenance is neglected or repairs, rebuilds, or adjustments are not performed in accordance with the manufacturer’s design criteria. Therefore, maintenance facilities (on or off premises), trained personnel, and detailed procedures shall be provided. Maintenance and inspection of the unit shall be performed in conformance with the following practices: A a schedules planned maintenance, lubrication, and inspection system shall be followed; consult the manu facturer’s recommendations. B only tranined and authorized person nel shall be permitted to maintain, re pair, adjust, and inspect the unit, and in accordance with manufacturer’s specifications. Avoid fire hazards and have fire protection equipment present in the work area. Do not use open pans of fuel or flammable cleaning fluids for cleaning parts. FIRE SAFETY STANDARD Any unit not in safe operating condition shall be removed from service. Fire Prevention: The unit shall be kept in a clean condition and reasonably free of lint, excess oil, and grease. Noncombustible agents are preferred for cleaning the unit. Flammable liquids [those having flash points at or above 100°F (37,8°C)] are not allowed. Precautions regarding toxicity, ventilation, and fire hazard shall be appropriate for the agent or solvent used. Nameplate Visibility: The unit type designations as shown on the nameplate and the type markers shall not be covered over with paint so that their identification information is obscured. Safety information for! sweeper Please ensure you read and note the following before using the unit! Please notify the firm which sold you the unit if you find any transport damage while unpacking it. Before starting up, please read the operating instructions for your unit and in particular, heed this safety information. Practical operation Before using, check that the unit and the working equipment are in good working order and are safe to operate. Do not use the unit unless it is in a perfect condition. The sweeper is not suitable for sweeping up liquids. Do not sweep up burning or glowing objects, e.g. cigarettes, matches or similar. Use sturdy gloves when removing glass, metal or other materials from the dirt container. This unit is not suitable for sweeping up substances harmful to health. It is forbidden to stay in the danger zone. It is prohibited to operate the unit in potentially explosive rooms. Operation The operator shall use the unit for its intended use. When operating the unit they shall take into consideration the local circums...