Stimmen - 2, Durchschnittliche Bewertung: 3.5
(
)
)
|
Anleitung Zusammenfassung
(Refer to Figure 1.) CHASSIS SERIAL NUMBER Figure 1 MODEL_ Engine serial number plate is located on the engine shroud. (Refer to Figure 2.) ENGINE 'SERIAL NUMBER Figure 2 DELIVERY DATE 7 SECTION I. CONTROLS Your Cub Cadet Tractor has been safety engineered. Thoroughly acquaint yourself with all the instruments and controls before attempting to start or operate the tractor. A. CHARGE INDICATOR This instrument indicates whether the alternator is charging or the battery is discharging. If it shows discharge continuously, investigate the cause to avoid completely discharging the battery and possible damage to the charging circuit. (Refer to Figure 3.) Figure 3 A. Charge Indicator B. Electronic Monitor C. Ignition Switch/Light Switch D. Lift Handle E. Power Take-Off (PTO) F. Brake Pedal G. Brake Pedal Lock H. Choke Control I. Throttle Control Lever J. Speed Control Lever K. Interlock Safety Switches (not shown) B. ELECTRONIC MONITOR (Refer to Figure 4) In Reverse Gear - will be illuminated when tractor is in reverse. Light must be off to start tractor. Do Not Engage PTO - will be illuminated while tractor is in reverse. NOTE PTO will not stay engaged with tractor in reverse - switch only will engage. PTO On - light will be illuminated when PTO switch is engaged. Light must be off to start tractor. Depress Pedal - light will illuminate when key is in "START" position and brake pedal is not depressed. Light must be off to start tractor. Full Throttle Required (two indicators) - top light will be illuminated when the PTO is engaged. Bottom light will be illuminated when the light switch is on. NOTE The unit should be run at full throttle when using PTO operated equipment or when the headlights are on. In Reverse Gear /* Full Throttle Required Do Not Engage PTO r ai ' Full Throttle Require^ Figure 4 C. IGNITION/LIGHT SWITCH NOTE Remove the key from the tractor when the tractor is not in use to prevent accidental starting and battery discharge. The combination lights and ignition switch is a four-position switch. (Refer to Figure 5.) Figure 5 8 D. LIFT HANDLE This lever is used to raise and lower equipment used with the tractor. The equipment can be set in six positions by depressing the button on the top of the lever and releasing it when the desired position is reached. (Refer to Figure 6). Figure 6 E. POWER TAKE-OFF (PTO) The power take-off is an electric clutch operated by a toggle switch on the left side of the instrument panel. When PTO is engaged, throttle should be in fast position. (Refer to Figure 3.) F. BRAKE PEDAL A CAUTION When the brake pedal is fully depressed, the brake pedal lock will automatically engage. To disengage the brake pedal lock, press down on the pedal slightly. Lift the brake pedal lock up and release the pedal. The brake pedal is located on the left side of the tractor. When the pedal is fully depressed, the speed control lever is automatically moved to the neutral position if the linkage is properly adjusted. (Refer to Figure 7.) G. BRAKE PEDAL LOCK A WARNING The hydrostatic transmission will not hold the tractor on a hill. In a short period of time (depending on the steepness of the hill) the oil will drain from the transmission and allow the tractor to roll downhill. To avoid an accident and/or possible injury, lock the brake. Always lock the brake when tractor is parked on a grade. To lock the brake, depress brake pedal and place the brake pedal lock in the engaged position. (Refer to Figure 7.) To disengage the lock, press down on the pedal, lift the lock up and place it in the disengaged position. Figure 7 1. Brake Pedal 2. Brake Pedal Lock H. CHOKE CONTROL The choke control is located on the instrument panel directly below the steering column. The choke control is operated manually. Pull knob out to choke engine. Push knob in to open choke. (Refer to Figure 3.) I. THROTTLE CONTROL LEVER This lever controls the speed of the engine. When set in a given position, it will maintain a uniform engine speed. (Refer to Figure 3.) When using power take-off operated equipment, best performance is achieved with the throttle lever in the "FAST" position. «48^” “Turtle” This symbol shows slow position. “Rabbit” This symbol shows fast position. J. SPEED CONTROL LEVER The speed control lever is located on the upper right hand side of the instmment panel. Move the speed control lever forward for various forward tractor speeds or backward for various reverse tractor speeds. (Refer to Figure 8.) 9 HYDROSTATIC DUMP VALVE LEVER K. INTERLOCKS This tractor is equipped with a safety interlock system for the protection of the operator. If the interlock system should ever malfunction, do not operate the tractor. Contact your authorized Cub Cadet dealer. The safety interlock system prevents the engine from cranking or starting unless the brake pedal is fully depressed, and the PTO switch is in the "OFF" position. The sa...