Stimmen - 3, Durchschnittliche Bewertung: 4.3
(
)
)
|
Anleitung Zusammenfassung
See figure 15. 5. Reassemble the belt cover, making sure the new belt is over the engine pulley. 6. When tightening the castle nut, only tightt., enough to line up hole in bolt for cotter pin. DO NOT OVERTIGHTEN. Belt cover must pivot freely. See figure 15. 8 FIGURE 15 7. Set edger back on its wheels. Replace spark plug wire. OFF-SEASON STORAGE The following steps should be taken to prepare unit for storage. 1. Clean and lubricate unit thoroughly. 2. Refer to engine manual for correct engine storage instructions. 3. Coat unit's cutting blade with chassis grease to prevent rusting. 4. Store unit in a dry, clean area. NOTE When storing any type of power equipment in an unventilated or metal storage shed, care should be taken to rustproof the equipment. Using a light oil or silicone, coat the equipment, especially springs and bearings. TROUBLE SHOOTING CHART PROBLEM CAUSE REMEDY 1. Engine fails to start. A. Check fuel tank for gas. B. Spark plug lead wire disconnected. C. Faulty spark plug. A. Fill tank if empty. B. Connect lead wire. C. Clean, adjust gap or replace. 2. Hard starting or loss of power. A. Spark plug wire loose. B. Dirty air cleaner. A. Connect and tighten spark plug wire. B. Clean air cleaner as described in engine manual. 3. Engine overheats. A. Carburetor not adjusted properly. B. Air flow restricted. C. Engine oil level low. A. Adjust carburetor. See engine manual. B. Remove blower housing on engine and clean as described in the engine manual. C. Fill crankcase with the proper oil. 4. Excessive vibration at blade. A. Spindle bolt bent. B. Ball bearing worn out. A. Replace spindle belt. B. Replace ball bearing. n 5. Belt slips. A. Belt worn or stretched. B. Clutch handle will not remain in clutch plate. A. Replace belt. B. Readjust spring tension at clutch handle. NOTE: For repairs beyond the minor adjustments listed above, please contact your local service dealer. 9 to 0Dieses Handbuch ist für folgende Modelle:
Handrasenmäher - 248-596-000 (1.07 mb)