Stimmen - 4, Durchschnittliche Bewertung: 3.8
(
)
)
|
Anleitung Zusammenfassung
and the flash will then return to normal. Installing the Batteries Install four size-AA batteries. 1 Open the cover. ..Slide the battery compartment cover as shown by the arrow and open it. 2 Install the batteries. ..Make sure the + and – battery contacts are correctly oriented as shown in the battery compartment. 3 Close the cover. ..Close the battery compartment cover and slide it as shown by the arrow. Recycling Time and Flash Count Recycling Time (Approx.) Flash Count (Approx.) 0.1 - 3.0 sec. 200 - 1400 ..Based on new size-AA alkaline batteries and Canon’s testing standards. ..Using size-AA batteries other than the alkaline type may cause improper battery contact due to the irregular shape of the battery contacts. ..If you change the batteries after firing many flashes continuously, be aware that the batteries might be hot. ..Use a new set of four batteries of the same brand. When replacing the batteries, replace all four at one time. ..Size-AA Ni-MH or lithium batteries can also be used. Attaching and Detaching the Flash 1 Attach the Speedlite. ..Slip the Speedlite’s mounting foot into the camera’s hot shoe all the way. (The mounting foot will protrude slightly from the hot shoe.) 2 Secure the Speedlite. ..On the mounting foot, slide the lock lever to the right. • When the lock lever clicks in place, it will be locked. 3 Detach the Speedlite. ..While pressing the lock-release button, slide the lock lever to the left and detach the Speedlite. Before attaching or detaching the Speedlite, be sure to turn off the Speedlite. Turning on the Power Switch 1 Set the power switch to icon is lit in the viewfinder. 3 Take the picture. • When you press the shutter button completely, the flash will fire and the picture will be taken. • If a standard flash exposure was obtained, the flash exposure confirmation lamp (green) will light for about 3 sec. If the lens focal length blinks on the LCD panel, the periphery of the flash picture may turn out dark. Use the built-in wide panel (p.18). .. will be displayed on the LCD panel even if the camera is compatible with E-TTL II. ..If the flash exposure confirmation lamp does not light, move closer to the subject and take the picture again. With a digital camera, you can also increase the camera’s ISO speed. Using E-TTL II and E-TTL Autoflash in the Shooting Modes Just set the camera’s shooting mode to
(manual) and you can use E-TTL II/E-TTL autoflash. X Select this mode when you want to set the shutter speed manually. The camera will then automatically set the aperture matching the shutter speed to obtain a standard exposure. ..If the aperture display blinks, it means that the background exposure will be underexposed or overexposed. Adjust the shutter speed until the aperture display stops blinking. W Select this mode when you want to set the aperture manually. The camera will then automatically set the shutter speed matching the aperture to obtain a standard exposure. If the background is dark like a night scene, a slow sync speed will be used to obtain a standard exposure of both the main subject and background. Standard exposure of the main subject is obtained with the flash, while a standard exposure of the background is obtained with a slow shutter speed. ..Since a slow shutter speed will be used for low-light scenes, using a tripod is recommended. ..If the shutter speed display blinks, it means that the background exposure will be underexposed or overexposed. Adjust the aperture until the shutter speed display stops blinking. q Select this mode if you want to set both the sh...