Stimmen - 1, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
3000 pages Drum cartridge yield* Initial starter cartridge (included with machine): (continuous printing, 20,000 pages (average) 5% page coverage, Replacement cartridge (FO-25DR): A4 paper) 20,000 pages (average) Paper tray capacity Approx. 220 sheets (80 g/m2 A4-size copier paper at room temperature; maximum stack height should not be higher than the line on the tray) Recommended paper weight: 80 g/m2 Printer type Laser Print resolution 600 . 600 dpi (dots per inch) Effective printing width 202 mm max. PC print speed** 11 ppm (pages per minute) max. *The yields may vary depending on coverage and operating conditions. **Measured based on A4-size continuous printing (3rd through 14th page), excluding warm-up time. Fax specifications Memory capacity* Approximately 600 average pages Modem speed 33,600 bps with auto fallback to lower speeds. Transmission time* Approx. 3 seconds Compatibility ITU-T (CCITT) Super G3, G3 mode Compression scheme MR, MH, MMR Applicable telephone line Analog public switched telephone network (ES203021) / PBX Reception modes AUTO, MANUAL Scanning Resolution Horizontal: 8 lines/mm Vertical: Standard: 3.85 lines/mm Fine /Halftone: 7.7 lines/mm Super fine: 15.4 lines/mm Halftone (grayscale) 64 levels Contrast control Automatic/Dark selectable *Based on Sharp Standard Chart at standard resolution, excluding time for protocol signals (i.e., ITU-T phase C time only). Network and general specifications Automatic document A4: 30 sheets max. (80 g/m2 paper) feeder Input document size Automatic feeding: Width: 148 to 216 mm Length: 140 to 297 mm Manual feeding: Width: 70 to 216 mm Length: 140 to 356 mm Effective scanning width 208 mm max. Storable transmission Rapid Keys: 36 destinations Speed Dial numbers: 114 Telephone function Yes (cannot be used if power fails) Copy function Single/Multi/Sort (up to 99 copies per page) Network interface 10 Base-T, 100 Base-TX Network frame type IEEE802.2/IEEE802.3 Ethernet II Network protocol TCP/IP Scan to E-mail Yes Scan to Network Folder Yes File formats TIFF (G4), PDF (G4) Supported operating Windows® 2000, XP, Server 2003, Vista systems (printer driver) Display LCD display, 20 digits x 2 lines Power requirements 220 - 230 V AC, 50 Hz Noise emission Less than 70 dBA (measured according to EN ISO 7779) Power consumption Standby: 8.5 W when not connected to a network 9.0 W when connected to a network Maximum: 750 W Operating temperature 10 - 30°C Humidity 20 - 85% RH Dimensions Width: 426 mm (without attachments) Depth: 410 mm Height: 208 mm Weight Approx. 7.1 kg (with attachments) As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from these values in individual units. Important: This machine is not designed for use on a line which has call waiting, call forwarding, or certain other special services offered by your telephone company (errors may occur during transmission and reception of faxes). This machine is not compatible with digital telephone systems. Important safety information Do not disassemble this machine or attempt any procedures not described in this manual. Refer all servicing to qualified service personnel. Do not install or use the machine near water, or when you are wet. For example, do not use the machine near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement, or near a swimming pool. Do not spill any liquids on the machine. Unplug the machine from the power outlet and telephone socket and consult a qualified service representative if any of the following situations occur: - Liquid has been spilled into the machine or the machine has been exposed to rain or water. - The machine produces odors, smoke, or unusual noises. - The power cord is frayed or damaged. -The machine has been dropped or the housing damaged. Do not allow anything to rest on the power cord, and do not install the machine where people may walk on the power cord. This machine must only be connected to a 220 - 230 V, 50 Hz, earthed outlet. Connecting it to any other kind of outlet will damage the machine. Never insert objects of any kind into slots or openings on the machine. This could create a risk of fire or electric shock. If an object falls into the machine that you cannot remove, unplug the machine and consult a qualified service representative. Do not place this machine on an unstable cart, stand or table. The machine could be seriously damaged if it falls. Never install telephone wiring during a lightning storm. Never install telephone sockets in wet locations unless the socket is specifically designed for wet locations. Never touch bare telephone wires or terminals unless the telephone line has been disconnected at the network interface. Use caution when installing or modifying telephone lines. Avoid using a telephone ...