Login:
Stimmen - 2, Durchschnittliche Bewertung: 3.5 ( )

Anleitung Lennox Hearth, modell 48LSBF-B

Hersteller: Lennox Hearth
Dateigröße: 57.33 kb
Dateiname:
Unterrichtssprache:en
Link zum kostenlosen Download Hinweise finden Sie am Ende der Seite



Anleitung Zusammenfassung


Insert the screws through the side panel holes and screw them into the pilot holes just drilled. Model Estate 48 Fireplaces Note:The Center Wedge Clip located inside the track in the center of the door frame indicates the bottom of the frame. It is important that the frame be installed with the correct side up to insure smooth operation of the doors. Step 1. Lay the frame face down on a clean, soft surface to avoid scratching the brass. Note the two Phillips Screws mounted to Tinnerman nuts on each of the side panels, loosen these screws to allow adjustment of the position of these Tinnerman nuts. Position the nuts to align with the round holes on the Estate 48 attachment brackets (seeFigure 2). Do Not attach brackets to the door at this time. Attachment Bracket Step 2. Locate the Phillips heads of the screws just around the back of the firebox opening at both the right and left sides. The slots of the Estate 48 attachment brackets will engage these screws and be secured in place by their heads. Back these screws out about an 1/8 of an inch. Step 3. Position the Estate 48 attachment bracket within the fireplace opening with their black faces forward and their slots engaged around the screws backed out in the previous step. Snug up two (2) screws on each side, DO NOT TIGHTEN. The attachment brackets must be allowed to move in the following step. Step 4. Remove the Phillips screw from the Tinnerman nuts in the door frame assembly. Position the frame within the opening and align the Tinnerman nuts with the four round holes of the attachment brackets, two (2) on each side. Secure the frame to the brackets with the four (4) screws, DO NOT TIGHTEN. Step 5. Center the door frame within the opening, left to right and push door frame up to the top of the opening as far as it will go. Carefully tighten all screws, making sure they are not overtightened. Do Not obstruct the gaps to the left and right of the frame. These spaces are designed for inlet air to enter the fire box. Installing the Doors Install all doors as follows: Fold panes of right door back to back with handle down as shown in Figure 3. Tilt door so that it fits inside frame as shown. Next, insert Bottom Pin into Bottom Retainer Slot. Then tilt top of door toward vertical position making sure that all Pins and Door Guides are inside Track. Finally, slide Top Pin along Top Retainer Clip until Top Pin snaps into Top Retainer Slot. Repeat procedure for left door. Top (Narrow) Door Guide (Wide) Door Guide Retainer Clip Bottom BottomRetainer Handle Clip Pin Figure 3 Figure 2 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE ADJUSTMENT FOR DOOR ALIGNMENT ADJUSTMENT FOR DOOR ALIGNMENT If doors appear to close in correct position but do not latch (both doors do not stay closed), then there is a misalignment between the doors and the Center Wedge Clip. The Center Wedge Clip is located in the center of the bottom Track. In order to stay closed, the left and right doors must meet in the Middle of the Center W...

Dieses Handbuch ist für folgende Modelle:
Haustüren und Fenster - 38LSBF-B (57.33 kb)
Haustüren und Fenster - 43LSBF (57.33 kb)
Haustüren und Fenster - 43LSBF-B (57.33 kb)
Haustüren und Fenster - 48LSBF (57.33 kb)

Bewertungen



Bewerten
Vorname:
Geben Sie zwei Ziffern:
capcha





Kategorien