Stimmen - 3, Durchschnittliche Bewertung: 4 ( )

Hersteller: Lennox Hearth Dateigröße: 467.42 kb Dateiname: Unterrichtssprache:

Step 2. Align the engagement clip with the lowermost opening along the firebox side. Step 3. Snap the channel into place. Step 4. When the vent channel is properly positioned, the holes on each tab will align with the door pin holes at the top and bottom of the firebox opening. Step 5. Repeat this procedure for the other vent channel component. NOTE: READ ALL THE STEPS BEFORE STARTING THE INSTALLATION. INSTALLER NOTICE: THESE INSTRUCTIONS MUST BE LEFT WITH THE APPLIANCE. ALL WARNINGS, PRECAUTIONS AND INSTRUCTIONS IN THE NSTALLATION INSTRUCTIONS AND CARE AND OPERATION MANUALS PROVIDED WITH THE APPLIANCE APPLY TO THESE INSTRUCTIONS. IF YOU ENCOUNTER ANY PROBLEMS, NEED CLARIFICATION OF THESE INSTRUCTIONS OR ARE NOT QUALIFIED TO PROPERLY INSTALL THIS KIT, CONTACT YOUR LOCAL DISTRIBUTOR OR DEALER. PRE-ASSEMBLY NOTES: 36LBF / LBF-BS and 42LBF / LBF-BS BI-FOLD DOORS Before installing 36LBF/LBF-BS and 42LBF/LBF-BS bi-fold doors, the deflectors and center clip must be installed on the firebox. Step 1. Refer to Figure 3, below. Using a Phillips screwdriver, remove the three (3) factory-installed screws in the lower face of the firebox. Step 2. Position the left and right deflectors and the center clip as shown below, and attach using the three screws. Step 3. Proceed to bi-fold door installation procedures on the next page. ApplianceUpper Door Guide TrackDoorEngagement Clip(Engaged Clip) Spring Clip(Shown pulled away for clarity) Vent ChannelClearance Hole Center Clip Left Air Deflector Right Air Deflector Figure 4: Installation of Vent Channels on 50LBF/LBF-BS Step 6. Remove the factory-installed screw in the center front of the firebox. Step 7. Position the center clip as shown in Figure 5, below, and attach it using the two (2) provided screws. Step 8. Proceed to bi-fold door installation procedures on the next page. (Detail: Installation of left air deflector.) (Detail: Installation of center clip on top of both air deflectors. Figure 3: Installation of Air Deflectors and Center Clip on 36LBF/LBF-BS and 42LBF/LBF-BS (Detail) Figure 5: Installation of Center Clip on 50LBF/LBF-BS LENNOX HEARTH PRODUCTS • LBF SERIES BI-FOLD GLASS DOORS • INSTALLATION INSTRUCTIONS 3 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE INSTALLING THE BI-FOLD DOORS Step 1. Refer to Figure 1 on page 1 for correct door position. Starting with the left door panel, hold it at a slight angle to the door frame outer edge, with the top of the door tilted toward the center of the firebox. Step 2. Swing the lower outer corner of the door over the hole in the lower frame of the firebox opening, and insert the lower pivot pin into the hole (Figures 6 and 7, below). ALIGNING THE BI-FOLD DOORS The doors are properly aligned when the top door trim is in a straight, level line, and the vertical gap between the doors is even from top to bottom. To align the bi-fold doors: Step 1. Grasp one door handle, and loosen the lower door pivot pin using a 3/8" open-end wrench. Note: The upper door pivot p...

Herunterladen

Geben Sie zwei Ziffern: