Stimmen - 4, Durchschnittliche Bewertung: 4.3
(
)
)
|
Anleitung Zusammenfassung
Some of the USB devices mentioned above might not be compatible with this DVD Recorder + VCR. In other words, the USB host function of this product does not guarantee the compatibility with all of USB devices. • This DVD Recorder + VCR supports both the high and full speed USB devices (Does not support Low speed devices). Overview DF-H7DD3D-FB-I(GB) 2007.7.25 2:53 PM . ` 9 mac001 1200DPI 100LPI DF-H7DD3D-FB-I(GB) 2007.7.25 2:53 PM . ` 9 mac001 1200DPI 100LPI Precautions Handling the Unit When shipping the unit The original shipping carton and packing materials come in handy. For maximum protection, re-pack the unit as it was originally packaged at the factory. When setting up the unit The picture and sound of a nearby TV, VCR, or radio may be distorted during playback. In this case, position the unit away from the TV, VCR, or radio, or turn off the unit after removing the disc. To keep the surface clean Do not use volatile liquids, such as insecticide spray, near the unit. Do not leave rubber or plastic products in contact with the unit for a long period of time. They will leave marks on the surface. Cleaning the Unit To clean the cabinet Use a soft, dry cloth. If the surfaces are extremely dirty, use a soft cloth lightly moistened with a mild detergent solution. Do not use strong solvents such as alcohol, benzine, or thinners, as these might damage the surface of the unit. To obtain a clear picture The DVD Recorder + VCR is a high-tech, precision device. If the optical pick-up lens and disc drive parts are dirty or worn, the picture quality will be poor. Regular inspection and maintenance are recommended after every 1,000 hours of use. (This depends on the operating environment.) For details, please contact your nearest dealer. Remote Control Operation Range Point the remote control at the remote sensor and press the buttons. Distance: Within 23 ft (7 m) of the remote sensor. Angle: Within 30. in each direction of the remote sensor. Remote Control Battery Installation Detach the battery cover on the rear of the remote control, and insert two AAA batteries. Make sure the polarities (+ and -) are aligned correctly. Caution Do not mix old and new batteries. Never mix different types of batteries (standard, alkaline, etc.). Notes on Discs Handling Discs Do not touch the playback side of the disc. Hold the disc by the edges so that fingerprints will not get on the surface. Do not stick paper or tape on the disc. Storing Discs After playing, store the disc in its case. Do not expose the disc to direct sunlight or sources of heat, or leave it in a parked car exposed to direct sunlight, as there may be a considerable temperature increase inside the car, which could distort the disc. Cleaning Discs Fingerprints and dust on the disc can cause poor picture quality and sound distortion. Before playing, clean the disc with a clean cloth. Wipe the disc from the center outward. Do not use strong solvents such as alcohol, benzine, thinners, commercially available cleaners, or anti-static spray intended for older vinyl records. Yes No 9 INTRODUCTION DF-H7DD3D-FB-I(GB) 2007.7.25 2:53 PM . ` 10 mac001 1200DPI 100LPI Identification of ControlsIdentification of Controls Front Panel !@# 52$^*367)1 % &( ! STANDBY/ON Turns the DVD Recorder + VCR on and off. @ Cassette Compartment (VCR deck) Insert a video cassette here. # Disc Tray (DVD deck) Insert a disc here. $ VCR EJECT Ejects the tape in the VCR deck. % REC Starts recording. Press repeatedly to set the recording time. ^ STOP Stops playback or recording. & PLAY/PAUSE Starts playback of a disc or tape. Pauses playback or recording temporarily. * REW DVD: Skips to previous chapter. VCR: Rewinds the tape during Stop mode. Press during Play mode for fast reverse picture search. ( FF DVD: Skips to next chapter. VCR: Advances the tape during Stop mode. Press during Play mode for fast forward picture search. 10 4 ) Front Panel Display Shows the current status of the DVD Recorder + VCR. 1 COPY Copies from DVD to VCR (or from VCR to DVD). 2 PR+/. Scans up or down through memorized channels. Also moves up and down in menus. 3 SELECT DVD/VCR Toggles control between the DVD mode and the VCR mode. 4 OPEN/CLOSE (DVD) Opens or closes the disc tray. 5 AVF Input (VIDEO, L-AUDIO-R) Connects to the audio/video output of an external source (VCR, Camcorder, etc.). 6 DV Input Connects to the DV output of an external source (VCR, Camcorder, etc.). 7 USB Input Connects to the USB device with Flash memory. Identification of Controls DF-H7DD3D-FB-I(GB) 2007.7.25 2:53 PM . ` 11 mac001 1200DPI 100LPI DF-H7DD3D-FB-I(GB) 2007.7.25 2:53 PM . ` 11 mac001 1200DPI 100LPI Front Panel Display INTRODUCTION Channel PR23 TV Channel Input mode AV-1 AV-2 F-AV DV AV1 input AV2 input Front - AV input DV input Copy DVD to VCR copying VCR to DVD copying COPY COPY Recording on disc 11:15 REC RECP Indicates a DVD Timer recording is set. Indicates a DVD Timer Recording is in standby mode. Indicates the DVD is recording. OT...