Stimmen - 1, Durchschnittliche Bewertung: 5
(
)
)
|
Anleitung Zusammenfassung
(Other than built-in LCD monitor) • The connected TV is not set to receive DVD signal output. • Select the appropriate video input mode on the TV so the picture from the player appears on the TV screen. No sound. • The equipment connected via the audio/video cable is not set to receive DVD signal output. • Select the correct input mode of the audio receiver so you can listen to the sound from the player. • The volume is too low. • Adjust the volume. • The audio receiver or TV is turned off. • Turn on the equipment connected with the audio/video cable. The playback picture has occasional distortion. • The disc is dirty. • Eject the disc and clean it. • Player is in fast forward or fast reverse mode. • Sometimes a small amount of picture distortion may appear. This is not a malfunction. • The player was moved or given a shock. • Vibrating or shaking the player during playback may produce distortion. This is not a malfunction. If not restored to usual status, stop playback and start again. • The disc is not set firmly. • Remove the disc and set it again. Brightness is unstable or noises are present in the playback pictures. (Other than built-in LCD monitor) • The effect of copy protection. If you connect the player to a VCR, TV/VCR combination or video selector, the playback picture may be distorted as DVD video discs are copy protected. • Connect the player directly to the TV. Avoid connecting the player to a VCR or TV/VCR combination. 68 SDP75SWN_E_53-80.indd 68 2011/03/07 10:41:0 Symptom Cause Correction The player does not start playback. • No disc is inserted. • Insert a disc. • An unplayable disc is inserted. • Insert a playable disc. (Check the disc type, color system and region number.) • The disc is inserted upside down. • Insert the disc with the playback side down. • The disc is not inserted securely. • Insert the disc securely in the disc holder. • The disc is dirty. • Clean the disc. • The parental lock function is set. • Change the parental lock level. Playback does not follow the course of the disc’s program. • It is in the repeat playback mode, memory playback, etc. • These operations may prevent a proper progression of the contents. Buttons do not work. • Power supply fluctuations or other abnormalities such as static electricity may interrupt correct operation. • Turn the power off then turn it on. Or disconnect the AC adapter and insert it into the wall outlet again. The remote control does not work properly. • The remote control is not pointed at the remote sensor of the player. • Point the remote control at the remote sensor of the player. • The remote control is too far from the player. • Operate the remote control within about 9.9 feet (3 m). • The battery in the remote control is exhausted. • Replace the battery with new one. • The player’s remote sensor is exposed to a strong light source such as direct sunlight or other illumination. • Avoid the player from being exposed to a strong light source. 69 SDP75SWN_E_53-80.indd 69 2011/03/07 10:41:0 Other Specifications ■ Player Power supply DC 12 V (Rated current: 1.5 A (Maximum: during battery charging)) 120 V AC, 60 Hz (with the supplied AC adapter) Mass Approximately 890 g External dimensions (envelope) 200 x 41 x 165 mm (W/H/D)_ Signal system Standard NTSC Laser Semiconductor laser, wavelength 650 nm / 795 nm Operating conditions Temperature: 5°C to 35°C (41 °F to 95°F), Operation status: Horizontal
DVD-Player - SDP75SWN (755.11 kb)