Stimmen - 3, Durchschnittliche Bewertung: 3.7 ( )

Hersteller: Toshiba Dateigröße: 7.46 mb Dateiname: 235dfcbe-aba0-4576-8c8a-2d5f53a84993.pdf Unterrichtssprache:

Dieses Gerät hat auch andere Anweisungen:

Fernseher - MW20F51 (164.86 kb)

26 5T80101B [E]p23-27 26 3/8/05, 9:56 AM 27 Basic setup Select the desired channel to be added or deleted using Direct channel selection buttons (0–9) or / . Press MENU in the TV mode, then press or to select option. Press or to select “TV/CABLE”. 1 2 Press MENU repeatedly until the menu screen is 4 cleared. Press or to select “TV” or “CABLE”. 3 TV - VHF/UHF channels CABLE - Cable TV channels Cable TV chart The chart below is typical of many cable system channel allocations. TV/CABLE selection To memorize channels This unit is equipped with a channel memory feature which allows channels to skip up or down to the next channel set into memory, skipping over unwanted channels. Before selecting channels, they must be programmed into the unit’s memory. In addition to normal VHF and UHF channels, this unit can receive up to 113 cable TV channels. To use this unit with an antenna, set the TV/CABLE selection to the TV position. When shipped from the factory, this selection is in the CABLE position. ADD 0-9 CH 001 / / / / / MENU To ADD/DELETE channels Press or to select the “AUTO CH MEMORY”, then press . The TV will begin memorizing all the channels available in your area. Automatic memory tuning Press or to select “ADD/DELETE”, then 1 press . Press or to select “ADD” or “DELETE”, 3 whichever function you want to perform. 2 Note: You can not select option if you set the channel to “LINE1” or “LINE2”. 0–9 MENU / / / TV operation 5T80101B [E]p23-27 27 3/8/05, 9:56 AM TV operation TV operation Setting the V-Chip An age limitation can be set to forbid children to watch programs according to “TV RATING” and “MOVIE RATING” level set. To use the V-Chip function, you must register a password. To register password Notes: • If you forget the password, you cannot set the V-Chip. •To avoid forgetting the password, write it down and keep in the safe place. To change password 1 1 Press MENU, then press or to select option. Enter the new password using Number buttons (0–9), then press ENTER. 2 In the V-CHIP menu, press or to select “CHANGE PASSWORD”, then press .1 Enter the same password again using Number buttons (0–9) for safety, then press ENTER. 3 Press MENU repeatedly until the menu screen is cleared. 4 2 2 Press or to select “PASSWORD”. 3 3 Enter the password (4 digits) using Number buttons (0–9), then press ENTER. • If you put a wrong number, press CANCEL. “ ” appears instead of the number. 4 4 Enter the same password again using Number buttons (0–9) for safety, then press ENTER. Now the password was registered and V-Chip setting menu will appear on the display. 28 5T80101B [E]p28-33 28 3/8/05, 9:56 AM To set the V-Chip MENU / / / DISPLAY ENTER CANCEL 0–9 1 1 or to select desired rating. “V-CHIP SET”, then press In the V-CHIP menu, press or to select Press . 4 After setting, press ENTER. 2 2 OFF : MOVIE RATING is not set Press or to select “TV RATING”, then G: All ages press or to display the desired setting. PG : Parental guidance After setting, press ENTER. PG-13 : Parental guidance less than 13 years old OFF : TV RATING is not set R: Under 17 years old TV-Y : All children Parental guidance suggested TV-Y7 : 7 years old and above NC-17 : 17 years old and above TV-G : General audience X: Adult only TV-PG : Parental guidance TV-14 : 14 years old and above Press or to select “V-CHIP”. TV-MA: 17 years old and above 5 Press or to display “ON”. 6 Now your settings were set into the memory. When you select TV- Y7, TV-PG, TV-14 or TV-MA, press DISPLAY to show the contained rating. Press / / / to select the desired item you want. TV operation 3 3 Press or to select “MOVIE RATING”. Press MENU repeatedly until the menu screen 7 is cleared. To use after the TV is protected When the program applied to the V-Chip setting is received, enter the password, then press ENTER. Protection can be canceled. Note: The V-Chip function is activated only on programs that have the rating signal. 29 5T80101B [E]p28-33 29 3/8/05, 9:56 AM TV operation TV operation To set the on timer This feature allows you to have the unit automatically turn on at a predetermined time. If you program the ON TIMER once, the unit will turn on the programmed day (daily/weekly) at the same time to the same channel. ENTER / / / MENU PROGRAM To set the on timer EXAMPLE: Turning on the TV to channel 12 at 7:00 AM, MONDAY-FRIDAY. 1 1 Press MENU. Press or to select option. You can also select ON/OFF TIMER by pressing PROGRAM twice. 2 2 Press or to select “ON/OFF TIMER”, then press . 3 3 Press or to select “ON TIMER”, then press . 4 4 Press or to set the desired hour, then press . Set the desired minute, channel and daily or weekly timer date as in step 4.5 Press or to select “SET”, then press ENTER. Now the ON TIMER is set. 6 Press MENU repeatedly until the men...

Herunterladen

Geben Sie zwei Ziffern: