Stimmen - 1, Durchschnittliche Bewertung: 4 ( )

Hersteller: Haier Dateigröße: 1.18 mb Dateiname: ecab536c-7635-43ff-a162-6b29e18b670d.pdf Unterrichtssprache:

Compressor cycle must be complete to operate. Food temperature appears too warm: • Frequent door openings. • Allow time for recently added warm food to reach freezer temperature. • Check gaskets for proper seal. • Adjust temperature control to colder setting. Food temperature is too cold: • If temperature control setting is too cold, adjust to a warmer setting and allow several hours for temperature to adjust. Freezer runs too frequently: • This may be normal to maintain constant temperature during high temperature and humid days. • The door may have been opened frequently or for an extended period of time. • Check gasket for proper seal. • Check to see if the door is completely closed. • Check freezer compartment for blockage from frozen food packages, containers, etc. Freezer has an odor: • Interior needs cleaning. • Foods improperly wrapped or sealed are giving off odors. Power Interruptions • Occasionally there may be power interruptions due to thunderstorms or other causes. Remove the power cord from AC outlet when a power outage occurs. When power has been restored, replug power cord to AC outlet. If outage is for a prolonged period, inspect and discard spoiled or thawed food in freezer. Clean freezer before reusing. Vacation and Moving Care • For long vacations or absences, empty food from freezer, unplug your freezer and clean the door gaskets according to "General cleaning" section. Prop door open, so air can circulate inside. When moving always move the freezer vertically. Do not move with the unit lying down. Possible damage to the sealed system could occur. 11 Parts And Feotures 1. Temperature Control Adjustment 2.Fast Freeze Switch (orange switch) 3. Power-On Indicator (green switch) 4. Vinyl Coated Wire Basket 5. Interior Drain Plug (see insert) 6. Exterior Drain Plug 7. Lock and Key Installing Your Freezer Unpacking Your Freezer 1. Remove all packaging material. This includes the foam base and all adhesive tape holding the freezer accessories inside and outside. 2. Inspect and remove any remains of packing, tape or printed materials before powering on the freezer. Adjusting Your Freezer • Your freezer is designed for freestanding installation only. It should not be recessed or built-in. • Place the freezer on a floor strong enough to support it fully loaded. • When moving the freezer, never tilt it more than a 45-degree angle. This could damage the compressor and the sealed system. • If the freezer is tilted let it stand in an upright position for at least 24 hours prior to plugging. This is to allow the refrigerant to settle. Proper Air Circulation • To assure your freezer works at the maximum efficiency it was designed for, you should install it in a location where there is proper air circulation, plumbing and electrical connections. • The following are recommended clearances around the refrigerator: Sides...............4" (102mm) Top....................4" (102mm) Back...................

Herunterladen

Geben Sie zwei Ziffern: