Stimmen - 1, Durchschnittliche Bewertung: 3 ( )

Hersteller: Black & Decker Dateigröße: 1.07 mb Dateiname: Unterrichtssprache:

WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. CAUTION: Indicates a potentially haz ard ous situation which, if not avoided, may result in minor or mod er ate injury. CAUTION: Used without the safety alert symbol indicates a potentially hazardous situation which, if not avoided, may result in property damage. SYMBOLS The label on your tool may include the following symbols. V ..........................volts A..........................amperes Hz ........................hertz W ........................watts min ........................minutes ......................alternating current ......................direct current no ........................no load speed ..........................Class II Construction ........................earthing terminal ........................safety alert symbol .../min ..................revolutions or reciprocations per minute • When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. The following table shows the correct size to use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier gage. The smaller the gage number, the heavier the cord. Recommended Minimum Wire Size for Extension Cords Total Length of Cord 25 ft. 50 ft. 75 ft. 100 ft. 125 ft. 150 ft. 175 ft. 7.6 m 15.2 m 22.9 m 30.5 m 38.1 m 45.7 m 53.3 m Wire Size AWG 18 18 16 16 14 14 12 4 FUNCTIONAL DESCRIPTION 1) SWITCH 2) FORWARD / REVERSE / LOCK OFF SLIDER 3) FORWARD / REVERSE WINDOW 4) 6 POSITION CLUTCH COLLAR 5) LED WORK LIGHT 6) HEX SPINDLE 7) SCREW HOLDER 8) CHARGING CONTACTS 9) CHARGING INDICATOR 10) CHARGING CRADLE A B 4 10 9 8 6 7 5 1 2 3 90564630 li4000 revision.qxd:??????-00 BDL500 laser 5/25/10 7:45 AM Page 4 90564630 5/25/1 0 7:45 AM Page 6 C D I E F G H Safety Warnings and Instructions: Batteries • Do not disassemble or open, drop (mechanical abuse), crush, bend or or shred. • Do not modify or remanufacture, attempt to insert foreign objects into the battery, immerse or expose to water or other liquids, or expose to fire, excessive heat soldering irons, or put in microwave oven. • Only use the battery for the cordless tool system for which it was specified. • Only use the battery with a charging system specified by the manufacturer/supplier. • Do not short-circuit a battery or allow metallic or conductive objects to contact both battery terminals simultaneously. • Dispose of used batteries promptly according to the manufacturer/supplier .s instructions. • Improper battery use may result in a fire, explosion, or other hazard. • Battery usage by children should be supervised. WARNING: Never attempt to open the battery pack for any reason. If battery pack case is cracked or damaged, do not insert into charger. Do not crush, drop or damage battery pack. Do not use a battery pack or charger that has received a sharp blow, been dropped, run over or damaged in any way (i.e., pierced with a nail, hit with a hammer, stepped on). Damaged battery packs should be returned to service center for recycling. Safety Warnings and Instructions: Charging 1. This manual contains important safety and operating instructions. 2. Before using battery charger, read all instructions and cautionary warnings on battery charger and product using battery. CAUTION: To reduce the risk of injury, use charger only with this product. Batteries in other products may burst causing personal injury or damage. 3. Do not expose charger to rain or snow. 4. Use of an attachment not recommended or sold by Black & Decker may result in a risk of fire, electric shock, or injury to persons. 5. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting charger. 6. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress. 7. An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire, electric shock or electrocution. 8. Use only the supplied charger when charging your tool. The use of any other charger could damage the tool or create a hazardous condition. 9. Use only one charger when charging. 6 7 90564630 5/25/10 7:45 AM Page 8 10. Do not attempt to open There are no customer Return to any authorized 11. DO NOT incinerate the tool or batteries completely worn out. The batteries can explode in a Toxic fumes and materials are created when lithium ion battery 12. Do not charge or use battery in explosive flammable liquids, gases or dust. Inserting may ignite the dust or fumes. 13. If battery contents come into contact with the soap and water. If battery liquid gets into the eye, rinse water three minutes or until irritation ceases. If medical electrolyte is composed of a mixture of liquid organic WARNING: Burn hazard. Battery liquid may be fl...

Herunterladen

Geben Sie zwei Ziffern: