Stimmen - 4, Durchschnittliche Bewertung: 3.8 ( )

Hersteller: Metabo Dateigröße: 176.04 kb Dateiname: Unterrichtssprache:

4 Luftversorgung Der Arbeitsdruck fur dieses Werkzeug sollte 6 Bar nicht uberschreiten. Ein hoherer Arbeitsdruck sowie unsaubere Druckluft verkurzen die Lebensdauer und konnen unter Umstanden zu gefahrlichen Situationen fuhren. Kondenswasser in den Luftleitungen verursacht Schaden am Druckluftwerkzeug. Druckbehalter taglich entwassern. Filter im Lufteinla. mindestens wochentlich reinigen. Es wird empfohlen dem Gerat einen Druckminderer mit Wasserabscheider und einen Oler vorzuschalten. 5 Wartung Taglich vor Arbeitsbeginn einige Tropfen Pneumatikol in den Lufteinla. geben. 6 Technische Daten MHS 315 S MHS 450 S Arbeitsdruck: 6 bar 6 bar Luftverbrauch: 156 l/min 430 l/min Anschlu.gewinde: 1/4" 1/4" Empfohlene Schlauchgro.e: 9 mm Innen-O 9 mm Innen-O Gewicht: 1,2 kg 2,0 kg Schlagzahl: 3000/min 2900 - 3300/min Kolbendurchmesser: 19 mm 19 mm Hub: 67 mm 67 mm Vibration: 18,2 m/s2 10 m/s2 Schalldruckpegel LPA am Ohr des Bedienenden in Anlehnung an DIN 45 635 ff 88 dB 88 dB Das Gerausch dieses Mei.elhammers wurde nach DIN 45 635 ff; 84/537/EWG fur Mei.elhammer gemessen. GB GB 1 User Responsibility This tool will perform in conformity with the description contained in the instructions provided. This tool must be checked periodically. Defective equipment (including service leads) should not be used. Parts that are broken, missing, plainly worn, distorted or contaminated, should be replaced immediately. Should such repair or replacement become necessary, it is recommended that such repairs are carried out by qualified persons approved by metabo or its representatives. This tool or any of its parts should not be altered or changed from standard specifications. The user of this tool shall have the sole responsibility for any malfunction which results from improper use or unauthorized modification from standard specifications, faulty maintenance, damage or improper repair by anyone other than qualified person approved by metabo or its representatives. 2 Safety Precautions . Use only chisels approved for use with pneumatic chisel hammers . Always wear appropriate apparel (safety glasses, gloves, helmet) . Always disconnect from compressed air supply before servicing . The work place sound power level can exceed 85 dBA. In this case noise control measures for the operator are required. 3 Preparing for Operation Ensure compressed air is dry and air lines do not contain condensate. Set to desired impact power by adjusting the regulator screw. Use only chisels and bits in good operating condition and suitable for the job. Place chisel in spring retainer, hold retainer at front end and screw onto cylinder. To change the chisel hold rear end of spring retainer and unscrew from cylinder. Note: To prevent built-up of dust or foreign matter inside the chuck, lubricate with a few drops of machine oil every two working hours. 4 Air Supply The operating pressure for this air tool should not exceed 6 bar/87 psi. A higher operating pressure, as well as soiled air shorten the...

Herunterladen

Geben Sie zwei Ziffern: