Stimmen - 2, Durchschnittliche Bewertung: 4 ( )

Hersteller: Sioux Tools Dateigröße: 500.2 kb Dateiname: Unterrichtssprache:

When first lubricating a tool or if the tool exhaust has a high oil content, do not allow the exhaust air to come near very hot surfaces or flames. -Never lay the tool down until the working attachment has stopped moving. -When the tool is not in use, shut off the air supply and press throttle triggerllever to drain the supply line. If the tool is not to be used for a oeriod of time. first lubricate. disconnect from air supply &d store in a dry average room temperature environment. -If the tool is passed from one user to a new or inexperi- enced user, make sure these instructions are available to be passed with the tool. -Do not remove any manufacturer fitted safety devices where fitted, i.e., wheel guards, safety trigger, speed governors, etc. -Wherever possible, secure workpiece with clamps, avise, etc. to make it rigid so it does not move during the work operation. Keep good balance at all times. Do not stretch or overreach. -Try to match the tool to the work operation. Do not use a tool that is too light or heavy for the work operation. If in doubt, seek advice. -In general terms, this tool is not suitable for underwater use or use in explosive environments -seek advice from manufacturer. -Try to make sure that the work area is clear to enable the work task to be performed safely. If practical and possible, try to clear unnecessary obstructions before starting work. -Always use air hose and couplings with minimum work- ing pressure ratings at least 1 112 times the maximum working pressure rating of the tool. the feed hose before fitting, removina 7 or adjusting the working attachment fitted to the tool. -Before using the tool, make sure that a shut off device has been fitted to the supply line and the position is known and easily accessible so that the air supply to the tool can be shut off in an emergency. -Check hose and fittings regularly for wear. -Take care against entanglement of the moving parts of the tool with clothing, hair, ties, cleaning rags, rings, jewelry, watches, bracelets, etc.This could cause the body or parts of the body to be drawn towards andin contact with the moving parts of the tool and could be very dangerous. EasyTo Reach And Air Tool Recommended Air Supply System Figure 1 Page No 1 ...

Herunterladen

Geben Sie zwei Ziffern: