Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
* Thank you for the purchase of Pioneer product, please read Operating Instructions before use for the 1st time for correct operation. Keep this Operating Instructions for your future reference. English 7 Before Start Before Start 1. Accessory Check Up Check the following items when opening the package: • AC adapter . 1 • Remote control . 1 • Rubber foot . 4 a • Warranty card . 1 • Operating Instructions (This Document) 2. Remote Control Check Up • Remove the insulation insert as shown in illustration (a) b before 1st time use. • To replace battery, open the battery drawer in the direction CR2025,3V as shown in illustration (b). . WARNING • Do not use or store batteries in direct sunlight or other excessively hot place, such as inside a car or near a heater. This can cause batteries to leak, overheat, explode or catch fire. It can also reduce the life or performance of batteries. CAUTION • Do not use any batteries other than the ones specified. • When loading the battery into the remote control, set it in the proper direction, as indicated by the polarity marks ( . and .). • Do not heat batteries, disassemble them, or throw them into flames or water. • Batteries may have different voltages, even if they look similar. • To prevent leakage of battery fluid, remove the battery if you do not plan to use the remote control for a long period of time (1 month or more). If the fluid should leak, wipe it carefully off the inside of the case, then insert new battery. If a battery should leak and the fluid should get on your skin, flush it off with large quantities of water. • When disposing of used batteries, please comply with governmental regulations or environmental public institution’s rules that apply in your country / area. • Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. • Dispose of used battery cells immediately after replacement. Keep away from children. • If swallowed, please contact a doctor immediately. • Lithium batteries may present a fire or chemical burn hazard if misused. Do not disassemble, heat above 100 °C, or incinerate. 8 9 English Using the remote control The remote has a range of about 5 m (17 ft.) at an angle of about 30° from the remote sensor. Keep in mind the following when using the remote control: 30° 30° • Make sure that there are no obstacles between the remote and the remote sensor on the unit. • Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the unit’s remote sensor. • Remote controllers for different devices can interfere with each other. Avoid using remotes for other equipment located close to this unit. • Replace the batteries when you notice a fall off in the operating range of the remote. 3. Connect DC Power • Connect the AC adaptor’s DC plug to the DC IN jack on the back panel. Then connect the power plug on the other end to the power outlet. • Use only the AC adapter included in this package, do not use the power adapter of different specification. Before Start DC IN 5 m (17 ft.) Part names and functions Part names and functions Remote control 8 1. STANDBY/ON Switch between standby and on. 9 1 2. Shuffle Random playback of music tracks. 2 12 3. Fast backward / Previous 13 • Press and hold to fast reverse of the 3 current track. 4 10 • Skip backward to the beginning of the track or to the previous track. 5 14 4. MENU Access iPod/iPhone menu. 11 6 5. VOL + 7 15 Increase the volume. 6. VOL – Decrease the volume. 7. Mute Silence the unit or restore the sound. 8. Up Navigate up to select an item on iPod/iPhone menu screen. 9. ENTER Confirm the selection on iPod/iPhone menu screen. 10.Down Navigate down to select an item on iPod/iPhone menu screen. 11.Play / Pause • Play/pause/resume playback. PAIRING • Press and hold to perform pairing with Bluetooth device 12.Repeat Repeat one or repeat all 13.Forward / Next • Press and hold to fast forward of the current track. • Skip forward to the next track. 14.iPod Bluetooth Switch to iPod Bluetooth mode. 15.AUX Switch to AUX mode. 10 Part names and functions Part names and functions Top Panel 123 45 English 1. MODE Indicator • Light up Indicate green when the unit is in iPod Bluetooth mode. • Light up Indicate orange when the unit is in AUX mode. • In the standby mode, light up Indicate red for 3 seconds when APS*1 is OFF. • In the standby mode, light up Indicate green for 3 seconds when APS is ON. 2. STANDBY/ON • Switch between standby and on. Press and hold to go into standby. INPUT • Switch the mode of iPod Bluetooth and AUX. 3. Play / Pause • Play/pause/resume playback. PAIRING • Press and hold to perform pairing with Bluetooth device. 7 6 4. Mute • Silence the unit or restore the sound. . Blink MODE Indicator during Mute. • In the standby mode, press and hold to switch between APS on and off. 5. VOL + / • Adjust the listening volume. . The listening volume has a range from 0 to 30 (however, the unit is n...
Dieses Handbuch ist für folgende Modelle:Heimkino-Systeme - XW-BTS3-W (11.94 mb)