Stimmen - 1, Durchschnittliche Bewertung: 5 ( )

Hersteller: Dacor Dateigröße: 1.29 mb Dateiname: Unterrichtssprache:

To make the light stay on (or turn off) when the door is closed: • Push the light button. • Push the UP or DOWN button repeatedly until the desired brightness level flashes on the display. Push the LIGhT button to select the desired brightness level. • Push the ON/OFF button to exit set-up mode. 5 Operating Your Appliance Child-Resistant Lock The child resistant lock feature makes it more difficult for a child to tamper with the controls. The child resistant lock indicator appears on the display when the lock is on. To lock (or unlock) the control panel: • Push and hold the LIGhT button for about five seconds to enter set-up mode. The display will begin to flash. • Push the UP or DOWN button repeatedly until “c” flashes on the display. • Push the LIGhT button. “c0” or “c1” will flash on the display. -c0 means that the lock is off. -c1 means that the lock is on. • Push the UP or DOWN button to select the desired mode. Push the LIGhT button to select that mode. • Push the ON/OFF button to exit set-up mode. Door Lock (some models) Some units come equipped with a door lock to prevent unauthorized access. The door is unlocked when the key is in the vertical position and locked when in the horizontal position. Unlocked Locked CAUTION During locking or unlocking of the door, hold on to the key at all times. The lock cylinder is spring loaded and will eject the key if you release your grip. To lock the door: 1. With the door closed, insert the key into the lock as shown below. 2. Turn the key 90° counterclockwise. 3. Remove the key. To unlock the door: 1. Insert the key into the lock. 2. Turn the key 90° clockwise (to the vertical position). 6 Care and Cleaning WARNING To avoid possible injury due to electric shock, disconnect • the power cord or turn off power at the circuit breaker or fuse box before cleaning the appliance. Clean only the parts of the appliance listed in this manual. • Clean them only in the manner specified. Do not use a steam cleaner to clean this • appliance. Steam could penetrate the electrical components and cause a short circuit. Do not allow water or cleaning fluids to penetrate into the • electrical components or ventilation grill. CAUTION To avoid damage to your appliance’s surfaces and accessories during cleaning: Use only the types of cleaning solutions specified in this • manual. Do not use abrasives such as steel wool, scouring pads, • rough sponges or scrub brushes. Defrosting The compartment of your appliance defrosts automatically. Water may form on the rear wall as part of the defrost process. It drains into a reservoir at the back of the appliance and is heated so that it evaporates. Cleaning the Surfaces Stainless Steel Surfaces CAUTION Always wipe stainless steel (silver colored) surfaces with the grain. • Clean stainless steel surfaces with a mild solution of detergent and warm water. Rinse and dry with a soft, lint-free cloth. • You may also use Dacor Stainless Steel Cleaner (Dacor PN A302) on the stainless steel surfaces. Use it according to the directions on the package. • Stainless steel that is exposed to chlorine gas and moisture may have some discoloration. This discoloration is normal. If your unit is used in this type of environment, clean and polish your stainless steel more often. • If the surface discolors or rust appears, clean it quickly with a non-abrasive cloth and protect it. Glass Surfaces • To remove finger prints on glass surfaces, use a mild glass cleaner with a soft damp rag. Other Surfaces • Clean all other surfaces with a soft damp rag. You may soak the rag with a mild detergent solution. Replacing the Filter Air quality is an important part of preserving and maturing good wine. To maintain good air quality, your Dacor wine cooler or beverage center is equipped with an activated charcoal filter. It is located on the rear wall. Dacor recommends that you replace the filter at least once a year. Filters (Dacor PN 101844) can be obtained from your Dacor dealer, parts distributor or at To remove the old filter: 1. Disconnect the power cord from the electrical outlet or turn off power at the circuit breaker or fuse box. 2. Hold the filter by the handle in the center. 3. Turn it 90° to the left or right. Pull it out. 1) Turn handle 90° 2) Pull out To install the new filter: 1. Insert it with the handle in the vertical position. 2. Turn it 90° to the left or right until it clicks into place. 3. Reconnect the power. 7 Care and Cleaning The Light WARNING IMPORTANT: The interior light emits class 1M laser radiation. To avoid severe eye injury or electric shock, do not remove the light cover or attempt to change the light bulb. Only a qualified service technician should replace the light. The location of the light is shown below only so that the customer can determine if it is working. The light fixture is mounted in the ceiling toward the front of the unit. If it is not working, call your dealer or Dacor Customer Service to have it replac...

Herunterladen

Geben Sie zwei Ziffern: