Stimmen - 2, Durchschnittliche Bewertung: 3.5
(
)
)
|
Anleitung Zusammenfassung
If damage is discovered, file your claim immediately with the transport company. Perlick is not responsible for damage in transit. Plumbing No plumbing connections are required. Condensate from the cooling coil is automatically evaporated through a condensate pan located in the condensing unit section. Electrical The cabinet must be connected to a separately fused power source (see Electrical Specification Plate) and grounded in accordance with National and Local Electrical Codes. CAUTION: Do not attempt to operate the equipment on any other power source than that listed on the Electrical Specification Plate. Placing the Cabinet To assure maximum performance, fresh air must be allowed to circulate through the machinery compartment. Do not place anything in front of the cabinet that would obstruct air flow at these grilles. Do not place the unit in an unventilated small room. Cabinet should be leveled front to back and side to side. Installing Casters or Legs (optional) Attach casters or legs to the mounting bracket with the lockwashers and 1/4-20 hex head nuts provided. Attach bracket and leg/caster assembly to the side of the cabinet base using the 1/4-20 hex head selftapping machine screws provided. Anti-tip (without Legs or Casters) To prevent the cabinet from tipping forward and to provide a stable installation, the cabinet must be secured in place with an anti-tip device. A set of metal anti-tip brackets and installation screws (#10-3/4" wood screw) are supplied. These brackets should be attached to the floor, at the back of the cabinet; each bracket located to catch each rear leveling leg when the cabinet is pushed backward into position. THE ANTI-TIP BRACKETS MUST CATCH EACH OF THE LEVELING LEGS TO HAVE A STABLE AND SAFE INSTALLATION. Some installation sites might need to be modified to provide a secure surface for attaching the bracket. Refer to the illustration below for anti-tip mounting bracket locations. For sanitation purposes, it may be necessary to seal the base of the cabinet to the floor. This can be accomplished by laying a bead of silicone sealant between the base of the cabinet and the floor as shown by the figure below. When sealing the cabinet to the floor, make sure that the louvered front grill plate can still be removed for condenser maintenence and cleaning Temperature Control An adjustable temperature control is located inside the cabinet on the evaporator fan panel assembly. Approximate temperature operating range: 32° F. minimum and 42° F. maximum. Make adjustments as shown to attain the desired temperature. .. Colder Temperatures: Turn the adjusting screw clockwise (to the right). .. Warmer Temperatures: Turn the adjusting screw counterclockwise (to the left). .. Temperature Control “OFF”: Turn the adjusting screw completely counterclockwise to the “O” position until a click is noted. The condenser fan and the evaporator fan motor turns off and on with the compressor. Cleaning the Cabinet Use a mild detergent and water to clean the inside and outside of the cabinet. Dry thoroughly. Never use a scouring pad or abrasive cleanser. NOTE: An industrial strength, commercial cleaner can be used to clean the outside of painted cabinets. Cleaning the Condenser Use a long handled, stiff brush to clean the dirt from the front surface of the condenser. Keeping the condenser free from dust and dirt will ensure efficient operation. CAUTION: Do not bend the fins while brushing the front of the condenser. Avoiding Stainless Steel Corrosion Corrosion can be prevented by following product cautions, cleaning instructions and avoiding use of certain chemicals or objects which will cause stainless steel corrosion. STAINLESS STEEL ENEMY • Steel wool or steel scouring pads • Cherry/Orange/Olive juice • Chlorine Bleach • Sharp Objects ...