Stimmen - 2, Durchschnittliche Bewertung: 5
(
)
)
|
Anleitung Zusammenfassung
Ensure that they snap into place. See Figure 24. • Adjust the seat belt to be snug around the child’s waist. • Be sure that the BOTH of the child’s feet are fully on the platform at all times. • Be sure that BOTH of the child’s hands are holding the handles on the frame. Figure 23 Figure 24 ! WARNING NEVER allow a rear seated child to use the canopy as a hand hold. Caboose Ultralight Instruction Manual Page 10 Using the Stroller as an InfantCar Seat Carrier • To use the stroller to carry an infant car seat carrier, you must replace the Front Tray with the Car Seat Carrier Support. • Remove the Front Tray by pressing in on the lock tabs and pulling the tray off the brackets. Store the tray in a convenient place for later use. • Line up the female fittings on the Car Seat Carrier Support to the male fittings on the front of the stroller and push inward until the fittings snap into place. See Figure 25. Pull outward on both sides of the support to be sure both are snapped securely in place. • Push the canopy to its most rearward position. • ADJUSTTHESEATBACKTOITSRECLINED POSITION. • Remove the infant carrier from the car seat base. • Place the infant carrier onto the top of the stroller in a REAR FACING POSITION, locating the head end of the carrier so that it rests on the Car Seat Carrier Support and the feet end of the carrier so that it rests on the seatback, but NOT on the top edge of the seatback. See Figure 26. • Ensure that the head end of the infant carrier is pushed down firmly INSIDE the frame of the Car Seat Carrier Support and that it is centered side to side. • Remove the carrier restraining straps from the pouches on both sides of the stroller. Buckle them in place over the LOWEST part of the carrier sides. Adjust the straps so they are tight around the carrier but AWAY from the child’s neck. Pull up on the carrier to be sure it is held on securely. See Figure 27. • Always check frequently to be sure that the restraining straps are tight across the infant carrier but away from the child’s neck. • When you remove the infant carrier from the stroller, always replace the two restraining straps back into their side pouches. Figure 25 Figure 26 Figure 27 Page 11 Caboose Ultralight Instruction Manual ! IMPORTANT NOTE When using your stroller as an infant car seat carrier, the following are the compatible infant car seat models that the Caboose Ultralight will accommodate: • Baby Trend® Latch-Loc and Flex-Loc • Britax® Companion™ • Chicco® Key Fit Car Seat • Combi® Centre Series • Evenflo® Embrace™ • Graco® Safe Seat™ • Graco® Snug Rider™ Series • Maxi Cosi Mico • Combi® Connection • Compass® Light and Portable Infant Car Seat • Eddie Bauer® Infant Car Seat • Peg Perego® Primo Viaggio • Peg Perego® Primo Viaggio SIP • Safety 1st® Designer 22™ (models 22-625 and 22-626) For the most updated list of compatible infant car seats, please either check our website at or call our Customer Service Department at (877) 456-5049. ! WARNING ALWAYS install the infant carrier so that the child is facing toward the rear (handle) of the stroller with the restraining straps secured. ALWAYS position the infant carrier so that it is securely placed down inside the Car Seat Carrier Support frame. ALWAYS position the infant carrier so that it is resting ON the seatback, but NOT on the top of the seatback. NEVER position the carrier restraining straps on or near the child’s neck asthis may result in strangulation. Right Way Caboose Ultralight Instruction Manual Page 12 Folding the Stroller • Keep children away from stroller while folding. • Remove any infant carrier that has been installed on the stroller. Note that the stroller can still be folded with the car seat carrier support in place. • Position the stroller with the handle bar closest to you. • Place the canopy into its closed position and push it all the way forward toward the front of the stroller as far as it will go. • Make sure both rear wheel brakes are set to their locked positions. • Lock both front wheels in place with the locking levers facing forward. • To fold, unlatch the safety latch on the lower left side of the stroller. • Pull upward on the trigger mechanisms on both sides of the stroller. See Figure 28. • While these mechanisms are in the upward position, push forward on the stroller using the handle bar. • Once the stroller begins to fold, push the handle all the way forward and down until the stroller is completely folded. See Figure 29. CAUTION: While folding the stroller, be careful to keep your fingers from being pinched by moving parts. • Secure the stroller in the folded position by engaging the locking latch on the right side of the stroller over the extended rivet. See Figure 30. Figure 28 Figure 29 Figure 30 Page 13 Caboose Ultralight Instruction Manual Installing the Parent Organizer • Separate the hook & loop attachments in the open slot of the Organizer. • Orient the Organizer so that the cup holder is facing toward the fro...