Stimmen - 4, Durchschnittliche Bewertung: 3.3
(
)
)
|
Anleitung Zusammenfassung
WARNING Pull on each side of the Guardrail to make sure that it is completely attached. Do not lift the stroller by the Guardrail. Figure A Figure B Attaching the Kid's Tray Push the Kid's Tray into the guardrail posts on the armrest until they lock in place. Check to make sure each side is firmly attached. Removing the Kid's Tray Press the buttons on each side of the armrest while pulling the Kid's Tray away. Rear Wheel Assembly Attaching the Canopy Attaching the Kid's Tray 1. Insert wheel into rear axle (figure A) until it clicks into place. Pull wheel out to ensure it is secure. 2. Repeat this step with the opposite side. Removing the Rear Wheels Press the release lever as shown in Figure (B) while pulling the rear wheel away from the stroller. 1. Ensure the canopy is facing the proper direction. 2. Fully insert both sides of the canopy (male) into each side of canopy holders (female). 3. Attach the velcro located on each side of the canopy around the stroller handle. Removing the Canopy Pull the velcro apart, squeeze the bottom of the canopy holder (male) and pull the canopy off. CAUTION Failure to fully secure the canopy holders can cause the holders to bend. When storing the stroller by laying it down, be sure the canopy is off the ground to prevent it from bending. WARNING Pull on each side of the Guardrail to make sure that it is completely attached. Do not lift the stroller by the Guardrail. Figure A Figure B Attaching the Kid's Tray Push the Kid's Tray into the guardrail posts on the armrest until they lock in place. Check to make sure each side is firmly attached. Removing the Kid's Tray Press the buttons on each side of the armrest while pulling the Kid's Tray away. -4 Attaching the Parent Tray WARNING TO AVOID BURNS, never place hot liquids in Holding the Parent Tray with the center compartment facing toward you, align the tongue from both sides of the Parent Tray to the groove on the handle, located opposite the handle adjuster buttons. Slide Parent Tray down until it clicks into place and then pull up on it to be sure it is secure. ton, push the Parent Tray upward. Using the Rear Brakes CAUTION Push the stroller forward to ensure that the brakes are properly engaged. To lock brakes, push both brake levers DOWN. To unlock brakes, push both brake levers UP. Using the Reclining Backrest CAUTION Be careful when reclining the backrest while your baby is in the stroller to prevent abrupt changes in seating position. Never use seat in reclined position unless the permanently attached safety cover is used. WARNING the Parent Tray. To prevent tipping, DO NOT place more than 3 lbs. on the Parent Tray. Removing the Parent Tray Locate the tabs underneath the Parent Tray, on each side of the tray. While pull- ing the tab out toward the adjuster but- 1. Press the lever at the top of the seat to the left. 2. Adjust the backrest gently to any of three positions. To return the backrest to the upright position, simply lift the backrest gently into place. Using and Adjusting the 5-point Harness 1. Place the crotch belt between the baby’s legs. 2. Insert both waist belt buckles into the middle plastic piece. 3. Attach e hook to the t belt clips. 4. To adjus belt, lo CAUTION Avoid serious injury from falling or sliding out. Always use harness. both side - 5 CAUTION If seat cushion is ripped or torn, Removing/Attaching the Seat Cushion Removing 1. Unbuckle the 5-point harness and pull all the straps through the seat cushion. 2. Grasp the seat cushion at the top and unfasten from the velcro. Attaching 1. Pass the 5-point harness straps through the appropriate locations in the seat cushion. 2. Fasten the velcro. Folding the Stroller 1. Raise the backrest to the upright position. 2. Fold the canopy by lifting the canopy levers. 3. Lift up and hold the Folding Levers located on each side near the top of the handle as shown in the Figure (A). Then, tilt the stroller backward until it starts to fold. 4. Grasp the guardrail and handle in opposite hands and pull together. 5. Engage the folding latch on the side of the stroller as shown in the Figure (B). 6. Rotate handle to fold position as shown in the Figure (C). Figure C do not use. Do not use the stroller without the seat cushion. Figure A Folding Levers are located below the handle adjuster buttons on each side of the handle. Figure B Folding Latch -6 Using the Safety Cover (Boot) WARNING Child may slip into leg openings and strangle. Never use in reclined carriage position(s) unless safety cover (boot) is securely fastened. Velcro CAUTION Before folding the stoller, unfasten and store the safety cover (boot) under the seat. The stroller will not fold with it attached. Installing the Safety Cover (Boot) 1. Lift the seat cushion and pull safety cover (boot) out. 2. Place the safety cover (boot) over the guardrail and secure it with the velcro. Travel System WARNINGS NOTE: Make sure you use the Combi Centre Connectors provided with the stroller. When the Combi Centre I...