Hersteller: Huffy
Dateigröße: 112.04 kb
Dateiname: 4b0b2c1d-24d2-f9e4-c910-e3c624167c91.pdf
|
Anleitung Zusammenfassung
To ensure safety, do not attempt to assemble this system without following the instructions carefully. Check entire box and inside all packing material for parts. Before beginning assembly, read the instructions and identify parts using the hardware identifier and parts list in this document. Proper and complete assembly, use and supervision is essential for proper operation and to reduce the risk of accident or injury. A high probability of serious injury exists if this system is not installed, maintained, and operated properly. • Read and understand the warning label enclosed with hardware. It is the responsibility of the customer to mount this label. It should be affixed to the pole, wall, or door near playing area, at a height between 4-6 feet (1.22-1.83M) above ground level and in a location visible to all players. • During assembly, if using a ladder use extreme caution. Two people are recommended for this operation. • If technical assistance is required, contact Huffy Sports. • Serious injury could occur if teeth/face come in contact with backboard, net or rim. • Minimum operational height should be 6’6” (2M) to the bottom of backboard. Most injuries are caused by misuse and/or not following instructions. Use caution when using this unit. WARNING FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE. Owner must ensure that all players know and follow these rules for safe operation of the unit. In the U.S.: 1-800-558-5234 and Canada Only: 1-800-284-8339 In Australia: 1-800-632-792 206118 5/97 See instruction manual for proper installation and maintenance. Use caution when performing dunk type activities on this unit. Do not hang from any part of unit, including backboard, support braces, rim or net. Check unit before each use for loose hardware, excessive wear and signs of corrosion and repair before using. During play, use extreme caution to keep player's face away from the backboard, rim or net. Serious injury could occur if teeth/face come in contact with backboard, rim or net. During play, do not wear jewelry (rings, watches, necklaces, etc.) Objects may entangle in net. · · · · · · In U.S. and Canada only: IMPORTANT! Have questions...don’t go back to the store! We appreciate your purchasing one of our many fine products. We are sure that you will be very satisfied with your selection. Although great care and effort have been taken, occasionally problems may occur. To ensure prompt and correct handling of any problems, or to answer any questions, please contact our Toll-Free Customer Service Number listed below. Service will be quicker if you have your Model Number (found on carton) and assembly instructions ready when calling. PLEASE WRITE YOUR MODEL NUMBER IN THE SPACE PROVIDED ABOVE. Toll-Free Customer Service Number for U.S: 1-800-558-5234 and Canada Only: 1-800-284-8339 Internet Address: printed on recycled paper 1 07/01 P/N 211240A © COPYRIGHT 2000 by HUFFY SPORTS Parts List Item Qty. Part No. 1 1 206118 2 1 900033 3 1 203796 4 1 200318 5 1 203472 6 1 203470 7 1 203795 8 4 201611 Description Warning Label Slam Jam Bracket, Black Bolt, “Tee” 3/8 - NC x 5 Long Bracket Reinforcement, Slam Jam Spring, Black Washer, Flat 5/8 I.D. x 1-1/2 O.D. Nut, Special 3/8-NC Hex Flange Bolt 5/16-18 x 3 Long Item Qty. Part No. Description 9 4 201611 Hex Flange Bolt 5/16-18 x 2 Long 10 4 203309 Washer, 1 O.D. 11 4* 203100 Hex Flange Nut, 5/16 x 18 12 1 Rim 13 12 200120 Clips, Net Holder (Red) 12 200121 Clips, Net Holder (Black) 14 1 Net * QUANTITY USED MAY VARY BY MOUNTING METHOD. Item #2 (1) Item #5 (1) Item #7 (1) Item #10 (4) Item #6 (1) Item #3 (1) Item #4 (1) Item #8 (4) Item #11 (4) Item #13 (12) HARDWARE IDENTIFIER Item #9 (4) 2 P/N 211240A 07/01 1. 2 2. 7 6 Face of special nut (7) NOTE 4 5 3 must be flush with face of “Tee” bolt (3) as shown. 3. 8 or 9 10 11 3 07/01 P/N 211240A 4. 4. Install net clips (13) and net (14). The Quick Clip™ rapid release net system lets the net pull away from the rim. This reduces the risk of player injury or property damage. However, improper installation or a ball making contact at an odd angle may disengage the net clip from the goal rim. Usually, the clip is reinstalled with little or no problem. We hope that you agree this inconvenience is minor when compared to the safety of the players. Outside View 13 12 a. The two outer hooks on the clip must face towards inside of goal rim. Insert the larger hole in clip onto rim stud, then slide net clip to the left, locking or snapping securely into position. NOTE: Clips should not slide with ease. It is very important that the net clips are in the locked position before going on to next step. Inside View NOTE: Stretching net up then pulling side to side will help snap net under center hook. 14 b. Install net, as shown. IMPORTANT! MAKE SURE NET IS HELD BY ALL THREE HOOKS ON THE NET CLIP. WARNING: Use of this product without proper installation of net clips, or when all net...