• Tighten each waist belt so that the restraint system is snug against your child. Please refer to the next section for instructions to tighten the waist belts. • Apretar cada cinturon de la cintura de modo que el sistema de sujecion quede bien ajustado al nino/a. Consultar la siguiente seccion para mayores detalles sobre como apretar los cinturones. • Serrer les courroies de sorte que le systeme de retenue soit bien ajuste contre l'enfant. Pour serrer les courroies, consulter les instructions d

• Never use with an active child who may be able to climb out of the product. • Never leave child unattended. • Never use on an elevated surface. • Never use the toy bar as a handle. Para evitar lesiones o la muerte como resultado de caidas y quedar estrangulado en el sistema de sujecion: • Siempre usar el sistema de sujecion. • No usar con ninos activos que pueden salirse del producto. • No dejar al nino fuera de su alcance. • No usar sobre superficies elevadas. • No usar la barra de juguetes c

• Press and hold the bottom of the nap timer/clock button to choose 12-hour or 24-hour clock format. Press the top of the nap timer/clock button to make a choice. • Press the bottom of the nap timer/clock button . The hour number on the clock will fl ash. Press the top of the nap timer/clock button to scroll through hour choices. • Press the bottom of the nap timer/clock button . The minute numbers on the clock will fl ash. Press the top of the nap timer/clock button to scroll through minute cho

Use only on a fl oor. • Suffocation Hazard - Never use on a soft surface (bed, sofa, cushion) since the product can tip over and cause suffocation in soft surfaces. • Always use restraint system. • Never leave child unattended. • Never use as a car seat. • Not recommended for children who can sit up by themselves (6 months approximately, until 9 kg/20lb). • Never use toy bar as a handle. • Never use as a carrier or lift while child is seated. • Please read these instructions before assembly and

Tel: +603-3341 9052. Mattel Europa, B.V., Gondel 1, 1186 MJ Amstelveen, Nederland. Assembled Parts IMPORTANT! Please remove all parts from the package and identify them before assembly. Some parts may be packed in the pad. Both Shown Actual Size Note: Tighten all assembled screws with the enclosed Allen wrench. 2 Swing Housings Seat Bottom Seat Back 2 Side Rails Seat Pad Toy Bar Allen Wrench Base Hinge Rod Frame M6 x 25 mm Screw – 2 #8 x 2,5 cm Screw – 7 3 Assembly 2 • Position one of the swing

• Insert batteries as indicated inside the battery compartment. • Remove batteries during long periods of non-use. Always remove exhausted batteries from the product. Dispose of batteries safely. Do not dispose of product in a fire. The batteries inside may explode or leak. • Never short-circuit the battery terminals. • Use only batteries of the same or equivalent type as recommended. • Do not charge non-rechargeable batteries. • Remove rechargeable batteries from the product before charging. •

1 Hint: Remove the tray for use as a booster seat at a table. 79739b-0920.qrk 10/25/01 11:11 PM Page 11 • Locate the lock knobs on each end of the footrest. • Pull the lock knobs down and then slide them inward . The footrest unlocks for swing use. Swing Setup and Use 12 1 • To prevent falls when using the swing, never use with an active child who may be able to climb out of the seat. • Never leave child unattended. • To prevent serious injury or death from falls or sliding out, always use the r

Requires three “AA” batteries (included). Adult assembly is required. Tool required for assembly: Phillips screwdriver (not included). sher-price.com 73499 Stride-to-Ride Walker™ ™ Please keep this instruction sheet for future reference, as it contains important information. Requires three “AA” batteries (included). Adult assembly is required. Tool required for assembly: Phillips screwdriver (not included). Base 2 Caster Wheels Wheel AssemblyBasket Parts 3 Balls Backboard Shown Actual Size #8 x

10 Crotch Belt Waist Belt Waist Belt 1 •To prevent falls, never use with an active child who may be able to climb out of the seat. •Never leave child unattended. •To prevent injury or death from falls or sliding out, always use restraint system. Never rely on the tray to restrain child. WARNING B 2 Tighten B Loosen To tighten the restraint: •Feed the anchored end of the waist belt up through the buckle to form a loop . •Pull the free end of the waist belt . •Repeat this procedure to tighten the

•Repeat this procedure to assemble the other rear leg to the motor housing short tube. •Pull the rear legs down to be sure they are secure in the housings. If you can remove them, you have not assembled them correctly. Please re-read and repeat this assembly step. Button Rear Legs 4 Motor Housing Short Tube Tapered End Assembly 5 • Place the rear base on a flat surface so that the buttons face the front base. • While pressing the buttons on each side of the rear base, fit the rear legs onto the