Stimmen - 5, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
Side View of hanging bracket Topical view of hanging bracket The box should contain: Single Cotton Rope Swing (chain attached) 1 - “S” Hook 1 - Steel Hanging bracket 2 - 5/16 x 2” Hex Head Lag Bolts Assembly Instructions: NOTE: During shipping, the hanging chain may come apart from the swing chains. If this has occurred, lay the swing down and extend the swingchains from each end of the spreader bar toward acenter point. Place the hanging chain above theswing. Attach the hanging chain to the swing chainsusing the attached “S hooks.” Hanging Instructions: 1. Select a location for your swing that is 6 1/2 feet to8 1/2 feet above ground or floor level and will supporta maximum of 350 lbs. Position hanging systembracket along the center line of the beam on whichyou wish to hang your swing. Make sure beam has no knots or cracks or signs of rot. CAUTION: A. Mounting Hardware included is safety rated ONLYfor load bearing structures. The steel hanging bracketis not safety tested and approved for concretesurfaces, steel or plastic construction, particle boardand the like material, or vinyl siding. B. The steel hanging bracket is to make contact withmounting surface. Structural support unit mustaccommodate maximum safe weight limit of 350pounds. C. Prior to each use of your swing, inspect the ropesand other materials in your swing including but notlimited to: the mounting hardware, installation points, and objects supporting your swing for signs ofweakness or wear. Do not use if there are any signsthat the material or supports are not in propercondition. IF YOU HAVE ANY QUESTIONS CONCERNINGINSTALLATION, PLEASE CONSULT A BUILDING EXPERT. THE HAMMOCKSOURCE IS NOT RESPONSIBLE FOR IMPROPER INSTALLATION. 2. Mark drill holes on center line with a pencil wherethe bolt holes are located on the bracket and exposebare wood. 3. Drill holes where indicated by marked spots witha 1/4” drill, approximately 2” deep. 4. Position bracket with bracket holes over drill holes and start bolts by hand. Tighten with wrench or socket. Do not overtighten bolts. Bolts will strip the wood, thus causing a reduction in load capacity. 5. Affix “S” hook to hanging bracket. Hook the chain on the swing to the bottom of “S” hook. Adjust the Chain hungcorrectly. Chain hungincorrectly. Hanging Chain “S” Hooks Swing Chain height of the swing with the chain for maximum comfort. When sitting in the swing, your feet should touch theground with knees slightly bent. Note: The first time youhang the swing, it may seem too high off the ground, however; the ropes will stretch, bringing the swing to amore comfortable level. Simply adjust the chain to put your swingat the desired height. 6. The design of this swing providesample room for push-out” seating. After seated in the swing, the usercan place his or her feet at the edgeof the swing front and “push-out.” The roomy design of the front of theswing will provide a comfortablerest for the legs. WARNING: -Not recommended for use bychildren without adult supervision. -Your swing is not built to hold more than one person at a time. -Your swing is not designed for high, rough swinging ortwisting movements. - Do not allow the chain to twist as the strength of thechain is dramatically reduced when it is twisted. CARE AND MAINTENANCE: Thank you for purchasing the Hatteras Hammocks® Single Cotton Rope Hammock Swing. The Single Cotton Rope Hammock Swing is designed to be weatherable. However, in order to keep your swing in the best condition, bring it indoorsand out of extreme conditions. A solution of mild soap and water will remove most dirt and isnot harmful to the natural cotton fibers. For stains: spot cleanand rinse thoroughly. Sponge thoroughly with clean water andair dry. WARRANTY INFORMATION: Products of The HammockSource are guaranteed to be free of defects inworkmanship and materials for up to one year after the purchase date. Prolonged exposure to weather conditions including snow, rain, andhumidity are not covered under the warranty nor is damage caused bynormal wear, mildew, or improper care including storage, maintenance, and installation. If an item is found to be defective within one year of itspurchase, it will be replaced without charge upon the return of the unitaccompanied by a sales receipt. If you choose to return an item, you mustcontact our customer service department at 800.643.3522 to obtain aReturn Authorization Number that will allow us to track your unit once itarrives at our warehouse; thereby creating a faster response to your concern. 5037HB P.OJ ...