Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Anleitung Zusammenfassung
Why does the charging time of the parent unit
Noise/sound
exceed 2.5 hours?
• The parent unit may be switched on during
Why does the video monitor produce a high-
charging. Switch off the parent unit during
pitched noise?
charging.
• The units may be too close to each other. Make
sure the parent unit and the baby unit are at
Why do I need to keep the baby unit and its
least 1.5 metres (5 feet) away from each other
cord at least 1 metre/3.5 feet from my baby?
and set the volume to a lower level.
• To avoid strangulation with the cord and for
• The volume of the parent unit may be set too
optimal sound detection, always place the baby
high. Decrease the volume of the parent unit.
unit and its cord at least 1 metre (3.5 feet)
away from the baby.
Can I increase the volume of the lullaby on the
baby unit?
Indications on the parent unit
• No, you can’t.
Why doesn’t the battery status symbol appear
Why don’t I hear a sound/Why can’t I hear
on the video display of the parent unit when I
my baby cry?
start to charge the parent unit?
• The volume of the parent unit may be set too
• It may take a few minutes before the battery
low or may be switched off. Press the volume
symbol appears on the video display of the
up button to increase the volume level.
parent unit when you charge the parent for the
• Perhaps you did not remove the protective foil
first time or after a long period of disuse.
from the microphone. Make sure all protective
foil has been removed.
Why do the battery/power-on light and the
• Perhaps you have switched on the voice
battery symbol on the video display flash red?
activation. If the voice activation is activated, the
• If the battery/power-on light and the
video display only switches on when the baby
battery symbol on the video display flash
unit picks up a sound. As long as no sound is
red,the rechargeable battery of the parent unit
detected, the video display is off to save power.
is low. Connect the parent unit to the mains to
• Perhaps the video baby monitor is in auto mute.
recharge the battery (see chapter ‘Preparing for
When the baby unit detects a low sound level,
use’).
e.g. the sleeping sound of the baby, the parent
unit automatically mutes the sound output so
Why does the parent unit beep?
that you do not hear this sound. When the
• If the parent unit beeps while the out-of-
baby starts to cry, the parent unit automatically
range image appears on the video display, the
switches on the volume again to let you hear
connection with the baby unit is lost. Move the
the crying sound.
parent unit closer to the baby unit.
• The baby unit may be too far away from your
• If the parent unit beeps while the battery/
baby. Make sure the baby unit is not further
power-on light and the battery symbol on the
than 1.5 metres (5 feet) from your baby, but
video display flash red, the rechargeable battery
not closer than 1 metre (3.5 feet) to avoid a
of the parent unit is low. Connect the parent
strangulation hazard.
unit to the mains to recharge the battery (see
chapter ‘Preparing for use’).
• The baby unit may be switched off. Switch on
the baby unit.
14
...