Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Anleitung Zusammenfassung
• Refer all ser vicing to qualified ser vice personnel. Ser vicing is required when the clock radio has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the clock radio, the clock radio has been exposed to rain or moisture, does not operate normally, or has been dropped. • This clock radio shall not be exposed to dripping or splashing. • Do not place any sources of danger on the clock radio (e.g. liquid filled objects, lighted candles). • Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. Your clock radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the suppor t that Philips offers, register your product at What’s in the box B Overview of the main unit A 3 Get started Always follow the instructions in this chapter in sequence. Install battery D Warning • Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard bat teries in fire. • Danger of explosion if bat ter y is incorrectly replaced. Replace only with the same or equivalent type. • The bat ter y contains chemical substances, so it should be disposed of properly. • Keep children away from the batter y. Note • You can only use AC power as power supply. The lithium CR 2032 bat ter y is only for back-up purpose. • When power is disconnected, the display backlight is off. When appears on the display panel ( ) , replace the batter y as indicated. Connect power C Caution • Risk of product damage! Ensure that the power voltage corresponds to the voltage printed on the back or underside of the clock radio. • Risk of electric shock! When you unplug the AC adapter, always pull the plug from the socket. Never pull the cord. Plug and set The clock radio has “plug and set” feature. When power is connected, the clock is set automatically. Select time zone Check if the time of the clock radio is consistent with the local time. If not, adjust the time zone settings according to your location. 1 In standby mode, press TIME ZONE ( ). » The current time zone number blinks on the display panel. 2 Press TIME ZONE repeatedly to select time zone (-1 to +12 adjustable). For Europe: Western European Time ( WET) +0 Central European Time (CET ) +1 (Default) Eastern European Time (EET) +2 Moscow Standard Time (MST) +3 Set clock E In standby mode, you can set clock manually. Select DST (daylight saving time) mode For countries with daylight saving time (DST), the clock radio offers you DST option to adjust summer time. In standby mode, press and hold 12/24H·DST ( ) for two seconds. » The clock advances by one hour. Tip • To exit DST mode, repeat the above operation. • To select 12/24 hour format, press 12 /24 H· DST repeatedly. Set alarm timer Set alarm time F In standby mode, you can set two alarms to ring at different time. Select alarm sound To select the last heard channel or buzzer as alarm sound, switch AL1/ AL2 RADIO·BUZZ ( ) to left or right. Activate/deactivate alarm timer 1 Press AL1/AL2 ( ) to view alarm set tings. 2 Press AL1/AL2 again to activate or deactivate the alarm timer. » or appears if alarm timer is on and disappears if it is off. • To stop alarm, press the corresponding AL1/AL2 . • The alarm repeats ringing for the nex t day. Note • When alarm sounds, you cannot adjust volume by rotating VOL ( ). Snooze alarm When alarm sounds, press SNOOZE ( ). » The alarm snoozes and repeats ringing five minutes later. To adjust alarm inter val (in minutes), press SNOOZE repeatedly. 5 10 15 20 25 30 Listen to radio Tune to radio stations G Tip • Position the antenna as far as possible from T V, VCR , or other radiation source. • For better reception, fully ex tend and adjust the position of the antenna. Store radio stations automatically You can store up to 20 FM radio stations and 10 MW radio stations. 1 Press R ADIO ( ) to turn on the radio. 2 Press and hold PROG ( ) for two seconds. » The clock radio stores all the available FM radio stations and broadcasts the first available station automatically. Store radio stations manually 1 Tune to a FM/MW radio station. 2 Press PROG ( ). » The preset number begins to blink. 3 Press PRESET +/-( ) or TUNING +/-( ) repeatedly to select a number. 4 Press PROG again to confirm. 5 Repeat Steps 1 to 4 to store other stations. Note • To remove a pre-stored station, store another station in its place. Select a preset radio station In tuner mode, press PRESET +/-( ) to select a preset number. Adjust volume H Other features Set sleep timer This clock radio can switch to standby mode automatically after a preset period. Press SLEEP ( ) repeatedly to select sleep timer period (in minutes). »When the sleep timer is activated, is displayed. To deactivate the sleep timer, press SLEEP repeatedly until [OFF] (off) appears. 15 30 60 90 120 off Adjust display brightness Press BRIGHTNESS ( ) repeatedly to select dif...