Stimmen - 4, Durchschnittliche Bewertung: 4.3 ( )

Hersteller: Armitron Dateigröße: 399.39 kb Dateiname: Unterrichtssprache:

2. Press ‘A’ to measure Laps. 3. Press ‘C’ to stop timing at the end of the event. 4. Press ‘A’ to reveal the final Lap time. 5. Press ‘A’ again to reset to zero. 6. Press ‘B’ to return to Time Telling Mode. SETTING 24 HOUR ALARM 1. From Time Telling Mode, press ‘B’ twice to enter the Alarm Mode. 2. Press ‘A’. Alarm Hours flash. Press ‘C’ to advance the Alarm Hour. 3. Press ‘B’. Alarm Minutes flash. Press ‘C’ to advance the Alarm Minute. 4. Press ‘B’. Alarm Time Zone flashes. Press ‘C’ to select either Time Zone 1 or Time Zone 2. NOTE: The Alarm is available in one Time Zone only. 5. Press ‘A’ to end set sequence. 6. Press ‘B’ to return to Time Telling Mode. ACTIVATING THE ALARM AND HOURLY CHIME 1. While in Alarm Mode, press ‘C’ to activate the Alarm. The Alarm symbol appears to indicate the Alarm will sound at the preset Alarm Time for 20 seconds or until ‘A’, ‘B’ or ‘C’ is pressed. 2. Press ‘C’ again to activate the Hourly Chime. “CHIME” appears to indicate the Hourly Chime will sound every hour on the hour. 3. Press ‘C’ again to deactivate the Alarm. 4. Press ‘C’ again to deactivate the Hourly Chime. 5. Press ‘B’ to return to Time Telling Mode. COUNTDOWN TIMER 1. From Time Telling Mode, press ‘B’ three times to enter the Timer Mode. 2. Press ‘A’. Hours flash. Press ‘C’ to advance the Hour. 3. Press ‘B’. Minutes flash. Press ‘C’ to advance the Minute. 4. Press ‘B’. Seconds flash. Press ‘C’ to advance the Second. 5. When the Countdown Time is set, press ‘A’ to end set sequence and return to Timer Mode. 6. Press ‘C’ to start the Countdown Timer. 7. If desired, press ‘C’ again to stop the Countdown Timer. Press ‘C’ again to resume the Countdown Timer. 8. If desired, press ‘A’ to reset the Countdown time to the preset Countdown time. Press ‘A’ again, then press ‘C’ to restart the Countdown Timer. NOTE: The Countdown timing will continue in any mode until ‘C’ is pressed. When the Timer counts down below three minutes, an alarm (‘Beep Beep’) will sound when the Seconds Digit is ‘0’ or ‘30’. When the Timer counts down below ten seconds, an alarm (‘Beep’) will sound every second. When the Timer has expired, the alarm (‘Beep Beep Beep’) will sound for ten seconds or until ‘A’, ‘B’ or ‘C’ is pressed. 9. Press ‘C’ to stop the Timer. 10. Press ‘B’ to return to Time Telling Mode. WATER RESISTANCE This is a WATER RESISTANT watch. Do not operate the push buttons below the surface of the water. Should water or condensation appear in the watch, immediately have the watch checked. Water can corrode electronic parts inside the case. CHANGING THE BATTERY Change the battery when the watch becomes slow, the readout darkens or does not appear, or the backlight fails. Before removing the old battery, be sure to denote its polarity so that the new battery is installed in exactly the same way. Replace with one (1) CR2016 or equivalent only. This watch contains precise electronic components and should only be opened by a qualified watch technician. However, it is not necessary to return your...

Herunterladen

Geben Sie zwei Ziffern: