Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Anleitung Zusammenfassung
If the plug supplied with this equipment
WARNING
• The player is not disconnected from
has a detachable fuse cover, be sure to
the AC power source (mains) as long
attach the fuse cover after you change
as it is connected to the wall outlet,
To prevent fire or shock
the fuse. Never use the plug without the
even if the player itself has been
hazard, do not expose the unit
fuse cover. If you should lose the fuse
turned off.
cover, please contact your nearest Sony
to rain or moisture.
• If you are not going to use the player
service station.
for a long time, be sure to disconnect
To avoid electrical shock, do
the player from the wall outlet. To
not open the cabinet. Refer
IMPORTANT
disconnect the AC power cord (mains
servicing to qualified
If the plug supplied is not suitable for the
lead), grasp the plug itself; never pull
personnel only.
socket outlets in your home, it should be
the cord.
cut off and an appropriate plug fitted in
• AC power cord must be changed only
accordance with the following
at the qualified service shop.
The laser component in this product
instructions.
is capable of emitting radiation
On placement
exceeding the limit for Class 1.
• Place the player in a location with
The wires in this mains lead are coloured
in accordance with the following code:
adequate ventilation to prevent heat
Blue:
Neutral
build-up in the player.
Brown:
Live
• Do not place the player on a soft
As the colours of the wires in the mains
surface such as a rug that might block
lead of this apparatus may not
the ventilation holes on the bottom.
correspond with the coloured markings
• Do not place the player in a location
identifying the terminals in your plug,
near heat sources, or in a place subject
proceed as follows:
to direct sunlight, excessive dust or
The wire which is coloured blue must be
mechanical shock.
This appliance is classified as a CLASS 1
connected to the terminal which is
LASER product. The CLASS 1 LASER
On operation
marked with the letter N or coloured
PRODUCT MARKING is located on the
black. The wire which is coloured brown
• If the player is brought directly from a
rear exterior.
must be connected to the terminal which
cold to a warm location, or is placed in
is marked with the letter L or coloured
a very damp room, moisture may
The following caution label is located
red. Do not connect either wire to the
condense on the lenses inside the
inside of the unit.
earth terminal in the plug which is
player. Should this occur, the player
marked by the letter E or by the safety
may not operate properly. In this case,
earth symbol Y or coloured green or
remove the disc and leave the player
green-and-yellow.
turned on for about an hour until the
moisture evaporates.
WARNING
On adjusting volume
To prevent shock hazard, do not insert
• Do not turn up the volume while
the plug cut off from the mains lead into
listening to a portion with very low
a socket outlet. This plug cannot be used
level inputs or no audio signals. If you
For the customers in Canada
and should be destroyed.
do, the speakers may be damaged
CAUTION
when a peak level portion is played.
TO PREVENT ELECTRIC SHOCK,
On cleaning
DO NOT USE THIS POLARIZED AC
Precautions
• Clean the cabinet, panel and controls
PLUG WITH AN EXTENSION
with a soft cloth slightly moistened
CORD, RECEPTACLE OR OTHER
with a mild detergent solution. Do not
OUTLET UNLESS THE BLADES
On safety
use any type of abrasive pad, scouring
CAN BE FULLY INSERTED TO
• Caution — The use of optical
powder or solvent such as alcohol or
PREVENT BLADE EXPOSURE.
instruments with this product will
benzine.
increase eye hazard.
• Should any solid object or liquid fall
If you have any questions or
into the cabinet, unplug the player and
NOTICE FOR CUSTOMERS IN THE
problems concerning your player,
have it checked by qualified personnel
UNITED KINGDOM
please consult your nearest Sony
before operating it any further.
A moulded plug complying with BS
dealer.
1363 is fitted to this equipment for your
On power sources
safety and convenience.
• Before operating the player, check that
the operating voltage of the player is
Should the fuse in the plug supplied
identical with your local power
need to be replaced, a 5 AMP fuse
supply. The operating voltage is
approved by ASTA or BSI to BS 1362,
indicated on the nameplate at the rear
(i.e. marked with 2 or @ mark) must be
of the player.
used.
2EN
...Dieses Handbuch ist für folgende Modelle:
CD-Player - CDP-XE300 (229.99 kb)
CD-Player - CDP-XE500 (229.99 kb)