Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Fotos und technische Daten Sony SCD-XE800 |
Anleitung Zusammenfassung
On transporting the player
• Before transporting the player, be sure to remove the
Additional Information
disc from the player, and close the disc tray.
• Before transporting the player, be sure to disconnect
Precautions
any connecting cables. If any cable is connected, the
player and the connected components may be
On safety
damaged.
• Caution – The use of optical instruments with this
• Do not carry the player by taking hold of the AC
product will increase eye hazard.
power code (mains lead), disc tray, or AMS dial.
• Should any solid object or liquid fall into the cabinet,
Doing so may cause you to drop or damage the
unplug the player and have it checked by qualified
player.
personnel before operating it any further.
On inserting a disc
• AC power cord (mains lead) must be changed only at
When you insert a disc into the player, you may hear a
the qualified service shop.
transmission or a mechanical sound from the player.
On power sources
This indicates that the player is automatically adjusting
its internal mechanisms according to the inserted disc.
• Before operating the player, check that the operating
You may also hear the mechanical sound from the
voltage of the player is identical with your local
player when you insert a warped disc.
power supply. The operating voltage is indicated on
the nameplate at the rear of the player.
Note
• If you are not going to use the player for a long time,
For Super Audio CD players, it may take a longer time
be sure to disconnect the player from the AC power
from when a disc is loaded until the disc is played, than
source (mains). To disconnect the AC power cord
that for CD players. This is not a malfunction. Because
(mains lead), grasp the plug itself; never pull the
a Super Audio CD player must determine the type of
cord.
disc inserted, adjust the servo mechanism, confirm
copyright information, etc., automatically, it takes a
On placement
longer time to start playback of a Super Audio CD.
• Place the player in a location with adequate
ventilation to prevent heat build-up in the player.
If you have any questions or problems concerning your
• Do not place the player on a soft surface such as a rug
player, please consult your nearest Sony dealer.
that might block the ventilation holes on the bottom.
• Do not place the player in a location near heat
sources, or in a place subject to direct sunlight,
excessive dust or mechanical shock.
Notes on Discs
On adjusting the volume
Do not turn up the volume too much while listening to
On handling discs
a portion with very low level inputs or no audio signals.
• To keep the disc clean, handle the disc by its edge.
If you do, the speakers may be damaged when a peak
Do not touch the surface.
level portion is played.
• Do not stick paper or tape on the disc.
On moisture condensation
• If the player is brought directly from a cold to a warm
location, or is placed in a very damp room, moisture
may condense on the lenses inside the player. Should
this occur, the player may not operate properly. In
this case, remove the disc and leave the player turned
• Use only round-shaped discs. If you use a special
on for about an hour until the moisture evaporates.
shaped disc (e.g., star-shaped, heart-shaped, or
square-shaped, etc.), the player may be damaged.
On cleaning
• Do not use a disc with a seal attached on such as on
Clean the cabinet, panel, and controls with a soft cloth
a used disc or rental disc.
slightly moistened with a mild detergent solution. Do
not use any type of abrasive pad, scouring powder, or
solvent such as alcohol or benzine.
18GB
...