Stimmen - 3, Durchschnittliche Bewertung: 4
(
)
)
|
Anleitung Zusammenfassung
Recording/ Playback Cotton swab Erasur tan \/ \ I (1.:Q I,JJn .IJ, \ . After cleaning the heads and tape paths with a liquid head cleaning cassette or a moistened swab, wait until the cleaned parts are completely dry before inserting the tapes. To demagnetize the heads The heads may become magnetized after long-term use. This may narrow the output range of recorded tapes and increase noise, After 20 to 30 hours use, demagnetize the heads with any commercially available demagnetizer. Care of discs When a disc becomes dirty, wipe the disc from the center out with a cleaning cloth. After playing a disc, store the disc in its case. Do not leave the disc in places that are hot or humid. Care of tapes l Store tapes in their cases after use. . Do not leave tapes near magnets, motors, television sets, or any source of magnetism. This will downgrade the sound quality and cause noise. . Do not expose tapes to direct sunlight, or leave them in a car parked in direct sunlight. 21 ENGLISH If the unit fails to perform as described in these Operating Instructions, check the following guide. GENERAL There is no sound. Is the AC cord connected properly? l Is there a bad connection? (+ page 3) * There may be a short circuit in the speaker terminals. + Disconnect the AC cord, wait for at least 5 seconds, and then correct the speaker connections. l Was an incorrect function button pressed? Sound is emitted from one speaker only. Is the other speaker disconnected? The output sound is not stereo. l Is the Karaoke function turned on? (+ page 16) An erroneous display or a malfunction occurs. + Reset the unit as stated below. TUNER SECTION There is constant, wave-like static. l Is the antenna connected properly? (+ page 4) Is the signal weak? -+ Connect an outdoor antenna. The reception contains noise interferences or the sound is distorted. l Is the system picking up external noise or multipath distortion? + Change the orientation of the antenna. + Move the unit away from other electrical appliances. CASSETTE DECK SECTION The tape does not run. l Is deck 2 in pause mode? (+ page 11) The sound is off-balance or not adequately high. l Is the playback head dirty? (+ page 21) Recording is not possible. . Is the erasure prevention tab on the tape broken off? (+ page 12) l IS the recording head dirty? (+ page 21) Erasure is not possible. l Is the erasure head dirty? (+ page 21) Is a metal tape being used? High frequency sound is not emitted. l Is the recording/playback head dirty? (+ page 21) CD PLAYER SECTION The CD player does not play. l Is the disc correctly placed? (+ page 9) l Is the disc dirty? (+ page 21) Is the lens affected by condensation? + Wait approximately one hour and try again. To reset If an unusual condition occurs in the display window or the cassette decks, reset the unit as follows. 1 Press POWER to turn off the power, 2 Press POWER to turn the power back on while pressing . CLEAR. Everything stored in memory after purchase is canceled. If the power cannot be turned off in step 1 because of a malfunction, reset by disconnecting the AC cord, and connect it again. Then carry out step 2. Speaker svstem SX-NA502 : ,,, Cabinet type 3 way, bass reflex (magnetic shielded type) Speakers Woofer: 140 mm (5 5/8 in,) cone type Main unit CX-NA508 Tweeter: FM tuner section 60 mm (2 3/8 ifl,) cone type Tuning range 87.5 MHz tO 108 MHz Super tweeter: Usable sensivity (IHF) 13.2 dBf 10 mm (13/32 in.) Ceramk type Impedance 6 ohms Antenna terminals 75 ohms (unbalanced) Output sound pressure level 87 dBIWlm Dimensions (W x H x D) 235 x 324 x 250 mm AM tuner section (9 3/8X 12 7/8X 9 7/8in.) Tuning range 530 kHz to 1710 kHz (10 kHz step) Weight 3.3 kg (7Ibs4 OZ.) 531 kHz to 1602 kHz (9 kHz step) Usable sensitivity 350 pV/m Antenna Loop antenna Specifications and external appearance are subject to change without notice, Amplifier section Power output 60 W+60W (50 Hz–20 kHz, THD less than 1%, 6 ohms) Total harmonic distortion 0.05 % (50 W, 1 kHz, 6 ohms, DIN AUDIO) WCESYSTEM Inputs VIDEO/AUX: 150 mV (adjustable) The word “BBE” and the “BBE symbol” are trademarks of BBE MD: 150 mV (adjustable) Sound, Inc. MIC: 1.8 mV (10 k ohms) Under license from BBE Sound, Inc. outputs LINE OUT: 200 mV SUPER WOOFERS: 1.9V COPYRIGHT SPEAKERS: accept speakers of 6 Please check the laws on copyright relating to recordings from ohms or more discs, radio or external tape for the country in which the machine SURROUND SPEAKERS: is being used. accept speakers of 8 ohms to 16 ohms NOTE PHONES (stereo jack): accepts This equipment has been tested and found to comply with the headphones of 32 ohms or more limits for a Class B digital device, pursuant to Part 15 of the FCC Rules, These limits are designed to provide reasonable protection Cassette deck section against harmful interference in a residential installation. Track format 4 tracks, 2 channels stereo Im This equipment generates, uses, and can radiate radio frequency Frequency response 50 Hz – 15000 HZ energ...