Stimmen - 4, Durchschnittliche Bewertung: 3.3 ( )

Hersteller: Little Wonder Dateigröße: 903.11 kb Dateiname: Unterrichtssprache:

The use of light gauge lamp cords or sizes lighter than those specified above will result in loss of power, possible motor failure, overheating of cord and the possibility of fire. 6. Warning! These trimmers have been designed so they can only be operated when using both hands. Do not attempt to override this important safety feature in any way. 7. Hold trimmer firmly. For Single Edge Model, keep right hand on side handle and left hand on rear handle. For Double Edge Model, you can place either hand on either handle. Squeeze both switches. Tilt trimmer so cutting tooth is angled slightly toward the hedge or shrub and proceed to cut. Use overlapping sweeping motions away from your body to achieve a safe and even cut. The unit is designed to cut any type of hedge or shrub; however, thickness of cut should not exceed 1/2 inch in diameter. 1/2" Remove the plug from the socket before carrying out any adjustment, servicing, or maintainence. B. SERVICE MAINTENANCE GUIDE Area Gear Housing Blades Fasteners Labels Handles Guards / Safety Devices Maintenance Check Grease Inspect / Clean / Lubricate Inspect / Tighten / Replace Inspect / Replace Inspect / Replace Inspect / Replace Frequency Monthly After Each Use Before Each Use Before Each Use Before Each Use Before Each Use IMPORTANT- Time intervals shown are maximum. Actual use and your experience will determine the frequency of required maintenance. 7 1. A few drops of light (#10) oil should be placed on the back edge of each blade at each adjusting screw after approximately every four hours of normal operation. 2. To obtain trouble free trimming, it is necessary to keep the blades lubricated and clean. The gum that collects and builds up on the blades can be removed with 50-50 mixture of kerosene and #10 oil. Since a petroleum product can shorten the life of some plastics, it is necessary to remove excess oil-kerosene mixture from the plastic parts. Blades must be clean before they can be adjusted. Caution! Kerosene and oil are flammable. 3. A few drops of light (#10) or 3-in-1 oil should be put in the hole indicated on the bottom cover plate. This is necessary only at the beginning of a day’s operation. 4. Gear housing and motor bearings have been permanently lubricated with a special grease which should last for the life of the trimmer. When blades are replaced, or any other time that the bottom cover plate is removed, the grease must be checked for proper amount (approximately 3/4 full in the area of the gears), and a new gasket and new screws must be used to insure proper seating of cover plate. Use only Lubrico M3-3K9K grease (P/N 16-78A) in the gear housing. Lubrico M24M (P/N 16-78B) is to be used on the motor bearings. Lubrico is available through your local Little Wonder Dealer. 5. Before each use, inspect to be sure handles, safety devices and fasteners are secure and in place, and cord is not frayed. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or si...

Herunterladen

Geben Sie zwei Ziffern: