Stimmen - 4, Durchschnittliche Bewertung: 4.5 ( )

Hersteller: Jacuzzi Dateigröße: 5.29 mb Dateiname: Unterrichtssprache:

an infection, bacteria or virus) and/or respiratory ailments. Fill until water covers all jets but does not touch the bottom of the lowest headrest. (DO NOT OVERFILL!) ImporTanT: Always fill your spa through the filter bucket after draining. Failure to do so may cause air to be trapped in either pump, preventing the pump from circulating water. Remove the hose and replace the filter cartridge. Note: DO NOT overtighten filter cartridge, finger tight only! 3. Turn on power Turn on power to spa at the home’s circuit breaker to start boot up sequence (Sec. 10.0, page 25). The heater and filter pump will automatically activate after several seconds. If the control panel LED flashes water temperature and “COL” or “ICE” this is normal, refer to page 38 for additional information. 4. activate Jets pumps Turn on jets pump(s) to ensure proper mixing when adding start-up chemicals in step 5. 5. add start-up Chemicals Add the spa water chemicals as recommended by your authorized Jacuzzi dealer. See Section 13.0 “Water Quality Maintenance” (page 36) for general guidance. ! warnInG: rIsK oF poIsonInG or DeaTH. Never leave chemicals opened and accessible to anyone. Use chemicals according to the vendors instructions. Always store chemicals in a safe and/or locked location. Keep away from and out of reach of children. 6. establish a stable sanitizer reading Establish a stable sanitizer reading between 3.0-4.0 ppm chlorine or 2.0 4.0 ppm bromine. To ensure healthy water conditions, always maintain a constant sanitizer reading within the levels recommended by the Association of Pool and Spa Professionals/USA printed on the inside cover of this manual. If sanitizer levels cannot be stabilized, perform the decontamination procedure steps 9-16 on pages 20-22. note: The “decontamination procedure” steps 9-16 should also be used after the spa has been “Winterized” (Section 12.7 page 35) or has beensitting without power for an extended period. 7. set spa To Heat To warm spa water to a comfortable temperature, follow these steps: The LED display on the control panel displays the• actual temperature of the spa water. Press either the COOLER ( ) or WARMER ( ) button once to display the “set” temperature for 5 seconds. If you want the water to heat to a different temperature, simply press COOLER ( ) or WARMER ( ) within 5 seconds. The set temperature increases or decreases by one degree each time one of these buttons is pressed. The heater will turn off when the temperature corresponding to the • thermostat setting is achieved. Important Heater Details: The maximum water temperature setting for your spa is 104°F• (40°C) and the minimum setting is 65°F (18°C). For North American spas connected to a 40 amp service, jets pump • #1 must be set to low speed and jets pump #2 must be turned off to operate the heater. For Export spas connected to a 20 amp service, jets pump #1 must• be set to low speed and jets pump #2 must be tu...

Herunterladen

Geben Sie zwei Ziffern: