Stimmen - 4, Durchschnittliche Bewertung: 3.8
(
)
)
|
Anleitung Zusammenfassung
— Eastern and Pacific Times) Phone: (800) 831-7133 Fax: (800) 284-4151 Technical Support, USA Sanford, North Carolina, USA (8 A.M. to 5 P.M. — Eastern Time) Phone: (919) 566-8000 Fax: (919) 566-8920 Moorpark, California, USA (8 A.M. to 5 P.M. — Pacific Time) Phone: (805) 553-5000 (Ext. 5591) Fax: (805) 553-5515 Web site visit and to find information about our products Pentair Water Pool and Spa Europe Industriepark Wolfstee Toekomstlaan 30 B-2200 Herentals BELGIUM Phone : +32 25 99 11 Fax : +32 25 99 73 © 2006 Pentair Water Pool and Spa, Inc. All rights reserved. This document is subject to change without notice. 1620 Hawkins Ave., Sanford, NC 27330 • (919) 566-8000 10951 West Los Angeles Ave., Moorpark, CA 93021 • (805) 553-5000 Trademarks and Disclaimers. The Pentair Water Pool and Spa logo and the Legend Platinum II logo are registered trademarks of Pentair Water Pool and Spa, Inc. Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Pentair Water Pool and Spa, Inc. disclaims any proprietary interest in trademarks and trade names other than its own. P/N 370260 Rev. A 7/31/06 LX 2000PMEU Important Information: The Legend® Platinum II automatic pool cleaner comes ready to connect into a female threaded 1-1/2" dedicated return line. Other connections are possible, but they require additional fittings. For more information, please contact our Technical Support Department at 1-800-831-7133. Also, if you have a chlorinator, solar system or other air inducing equipment, please contact our Technical Support Department before you install the Legend® Platinum II. The following are important facts to remember before installing and operating the Legend® Platinum II. 1. Always disconnect the Legend® Platinum II from the pool wall when cleaning or back washing the pool filter. 2. After cleaning or back washing, let the filtration system run for at least five minutes before reconnecting the Legend® Platinum II. 3. New plumbing lines should be flushed out before installing the Legend® Platinum II. 4. The Legend® Platinum II should not be used to remove plaster dust in new pools. 5. Always remove the Legend® Platinum II before swimmers enter the pool. 6. Always handle the Legend® Platinum II with care. Do not let children or pets play with the unit: it is not a toy. 7. Always pick up the Legend® Platinum II by the Vacuum Tube especially when lifting the unit out of the water. 8. Unless checking the wheel RPM, do not handle the Legend® Platinum II while it is operating. 9. Always remove the Legend® Platinum II from the pool before chemical shock treatments. As a rule, any pool water that is unsafe for swimming is unsafe for the Legend® Platinum II. 10. Carefully cut the feed hose following the instructions on Page 3. By following these simple guidelines, you can help protect against injury and prolong the life of your Legend® Platinum II. Before the Legend® Platinum II is installed, please take a moment to record the serial number. This number is located on the back of the Legend® Platinum II near the rear jet. You will be asked this number when you contact our Technical Support Department. SERIAL #__________________________________ LEGEND® PLATINUM II INSTALLATION MANUAL • MANUEL D’INSTALLATION LEGEND® PLATINUM II TABLE OF CONTENTS I. Introduction ...................................................................................................................... 1 A. Thank You for Choosing the Legend® Platinum II ................................................... 1 B. What to Expect from the Legend® Platinum II ......................................................... 1 II. Installation Instructions .................................................................................................... 2 A. Legend® Platinum II Components ........................................................................... 2 B. Pool Connections ................................................................................................... 2 C. Installing the Twist Lock Pressure Relief Valve (Wall Fitting) .................................. 2 D. Pressure Testing Instructions ................................................................................. 3 E. Cutting the Feed Hose............................................................................................ 3 F. Hooking Up the Legend® Platinum II ....................................................................... 4 G. Checking Operation ............................................................................................... 4 H. Fine Tuning the Legend® Platinum II ....................................................................... 5 1. Thrust Jet Adjustment ....................................................................................... 5 2. Sweep Hose Adjustment .........................................................