Stimmen - 3, Durchschnittliche Bewertung: 4.3
(
)
)
|
Anleitung Zusammenfassung
Either + or -terminal may be used. Minimum total impedance is 1 ohm. © Fuses • Replace only with the same type and rating. © Power Input Connectors • +12V: Connect to the positive terminal of the vehicle's battery. 8 AWG wire is recommended. Install an appropriate fuse holder and fuse (40A minimum) within 18 inches of the battery. Make sure the wire is not damaged or pinched during installation. Install protective grommets when routing wires through the firewall or other sheet metal. • GND: Connect to the vehicle's chassis. Refer to the picture below. Factoiy Bolt Ring Connector below ring connector. • REM: Connect to the "Remote Out" lead from the source unit or to a source of switched +12V (ACC). © Aux Output Connectors (RCA) • Nonfiltered pass-through output. Connect to the input of an additional amplifier. © Input Connectors (RCA) • Connect to the RCA outputs from the source unit or signal processor. © Input-Level Control • Used to match the input level of the amplifier to the output level of the source unit. • See © for the adjustment procedure. O Protect LED • Illuminated under any of the following fault conditions: battery over/under voltage, short circuit in speaker wires, amplifier is too hot, amplifier's output circuit has failed (DC voltage is present in the amplifier's output). © Low-Pass Filter Frequency Control • 12dB/octave low-pass filter, variable from 32Hz to 320Hz. • See © for the adjustment procedure. © Power On LED • Illuminated when the amplifier is on. © Setting Input Level 0 Turn Input Level control counterclockwise to 6V (minimim). 0 With a dynamic music track playing, turn the head unit's volume control to the 3/4 position. H Turn Input Level control clockwise until the bass output is proportionate to the output of the high-frequency speakers, according to your preference. D Input level is now adjusted correctly. © Setting the Crossover 0 Crossover setting for subwoofers. Note: Acceptable frequency ranges are indicated in gray. This product is designed for mobile applications and is not intended for connection to the mains. A valid serial number is required for warranty coverage. Features, specifications and appearance are subject to change without notice. ÜBL Harman Consumer Group, Inc. 250 Crossways Park Drive, Woodbury, NY 11797 © 2008 Harman International Industries, Incorporated. All rights reserved. JBL is a trademark of Harman International Industries, Incorporated, registered in the United States and/or other countries. GT Series is a trademark of Harman International Industries, Incorporated. Part No. GT5A3011OM 7/08 H A Harman International Company Declaration of Conformity C€ We, Harman Consumer Group, Inc. 2, route de Tours 72500 Château du Loir France declare in own responsibility that the product described in this owner’s manual is in compliance with technical standards: EN 55013:2001+A1:2003 EN 55020:2002+Al:2003 Klaus Lebherz Harman Consumer Group, ...
Dieses Handbuch ist für folgende Modelle:Auto Verstärker - GT5A3011OM (989.89 kb)