Stimmen - , Durchschnittliche Bewertung: ( )

Anleitung PYLE Audio, modell PLAM1600

Hersteller: PYLE Audio
Dateigröße: 2 mb
Dateiname:

Unterrichtssprache:

Das Dokument wird geladen, bitte warten

HerunterladenSchließen

Das Dokument wird geladen, bitte warten

HerunterladenSchließen

And the ground cable gauge should be the same as the +12V DC. * Connect the +12V Power terminal to the battery (+) position terminal. An in-line fuse must be installed in the +12V power cable near the battery less than 50mm. Without one, an accidental short circuit could pose a fire hazard and damage your amplifier. Connect the fuse holder to battery, however, do not install fuse at this time. * Connect the GROUND Power terminal directly to the battery (-) position terminal or the car chassis. Ensure that all paint or other insulation is remove from around the hole area, and using self tapping screw, securely affix the bare wire ends to the vehicle chassis. Use as short as possible. * Many radio’s and other music sources have an output terminal for connection of the remote turn on of the power amplifier. CONNECT the output terminal to the amplifier REM control jack. If a radio doesn’t have a remote turn on feature, you can connect the REM pole to external switch for positive +12V ON/OFF. * To help minimize interference, it is best to run the power cables along the opposite side from the audio cables. Caution : The power cables must be connected tightly. A loose connection may cause malfunctions or interference noise or distortion. 2 2 CHANNEL AMPLIFIER - FEATURES PLAM1000/PLAM1200/PLAM2300 HIGH IN Accepts speaker level inputs from radios that do not line level (rCa) outputs LINE OUTPUT Allows you to connect additional amplifier OW IN OUTPUT HIGH IN I I i fuci BA8S EQ LOW XOVER HIOH o) (O)^W ~ ° 7 ra r o.'S: (>r) ,,,! (k)........Or) BASS EQ Allows you to select the bass boost 6dB/12dB High Pass variable High Pass Filter from 120Hz to 3KHz GAIN Adjusts the line level Input from mln to max 120Hz 3KHz LOW PASS Variable Low Pass Filter from 50Hz to 250Hz LINE INPUT Accepts line level (RCA) Inputs from 0. 1 to 1 volts CROSSOVER SWITCH Routes output of the low pass(LP), or the output of the high pass (HP) filter , or FULL to the internal power amplifier FUSE Protects both this amplifier and the automobile electrical system from short circuit conditions SPEAKER OUTPUT PROTECT + right - 0 + LEFT -I-BRIDGED-1 SPEAKER OUTPUT TERMINALS POWER ON LED Lights up when the amplifier is energized indicating the unit is on PROTECT LED Lights indicating the amplifier has gone into a protection mode 3 4 CHANNEL AMPLIFIER - APPLICATIONS PLAM1600/PLAM3000 4-CHANNEL MODE 2-16 Ohms 2-16 Ohms 2-16 Ohms 2-16 Ohms 8 Car stereo system 4 CHANNEL AMPLIFIER - APPLICATIONS INPUT CONNECTIONS * This amplifier has RCA connections for low level inputs. Low level signal is carried through RCA cables, it is preferred to use low level inputs to the amplifier if the head unit is equipped with the low level outputs. SPEAKER OUTPUT CONNECTIONS You do not need to make any adjustment for the input connection of amplifier before you connect the speaker output. * Connect right and left speaker wire to corresponding speaker output terminals of ...