Stimmen - 5, Durchschnittliche Bewertung: 4.2 ( )

Hersteller: JBL Dateigröße: 691.25 kb Dateiname: Unterrichtssprache:

Instead, please ask your authorized JBL car audio dealer about professional installation. INSTALLATION CHOOSING A LOCATION WARNINGS AND TIPS AND MOUNTING THE • Always wear protective eyewear when using tools. • Turn off the audio system and other electrical devices before you start. Disconnect the (–) negative lead from your vehicle’s battery. • At the installation sites, locate and make a note of all fuel lines, hydraulic brake lines, vacuum lines and electrical wiring. Use extreme caution when cutting or drilling in and around these areas. • Check clearances on both sides of a planned mounting surface before drilling any holes or installing any screws. Remember that the screws can extend behind the surface. • Before drilling or cutting holes, use a utility knife to remove unwanted fabric or vinyl to keep material from snagging in a drill bit. • When routing cables, keep input-signal cables away from power cables and speaker wires. • When making connections, make certain they are secure and properly insulated. • If the amplifier’s fuse must be replaced, use only the same type and rating as that of the original. Do not substitute another kind. AMPLIFIER Choose a mounting location in the trunk or cargo area where the amplifier will not be damaged by shifting cargo. Amplifier cooling is essential for proper amplifier operation. If the amplifier is to be installed in an enclosed space, make sure there is sufficient air circulation for the amplifier to cool itself. When mounting the amplifier under a seat, ensure that it is clear of all moving seat parts and does not affect the seat adjustments. Mount the amplifier so it is not damaged by the feet of backseat passengers. Make sure that the amplifier is mounted securely using nuts and bolts or the supplied mounting screws. Mount the amplifier so that it remains dry – never mount an amplifier outside the vehicle or in the engine compartment. INSTALLATION POWER CONNECTIONS The CS amplifiers require a reliable connection to the vehicle’s electrical system in order to perform optimally. See Figures 1, 2 and 3 for terminal connection locations. Please adhere to the following instructions carefully: Ground Connection Connect the amplifier’s Ground (GND) terminal to a solid point on the vehicle’s metal chassis, as close to the amplifier as possible. Refer to the wire gauge chart to determine minimum wire gauge size. Sand away any paint from this location; use a star- type-lock washer to secure the connection. Power Connection Connect a wire (see chart at right for appropriate gauge) directly to the vehicle’s positive battery terminal, and install an appropriate fuse holder within 18" of the battery terminal. Do not install the fuse at this time. Route the wire to the amplifier’s location, and connect it to the amplifier’s Positive (+12V) terminal. Be sure to use appropriate grommets whenever routing wires through the firewall or other sheet metal. Failure to adequately protect the positive wire from potential damage may result in a vehicle fire. When you are done routing and connecting this wire, you may install the fuse at the battery. Remote Connection Connect the amplifier’s Remote (REM) terminal to the source unit’s Remote Turn- On lead using a minimum of 18-gauge wire. NOTE: If your source unit does not have a remote turn-on connection, connect the amplifier’s (REM) terminal to the vehicle’s accessory circuit. Speaker Connections Refer to the application guides on the pages that follow. Speaker connections should be mad...

Herunterladen

Geben Sie zwei Ziffern: