See Fig. 4. Replace the pushbutton wiring and tighten the screws. Be certain the antenna wire is hanging down vertically and the receiver terminal numbers printed on the receiver case match the numbers on the operator terminal strip. (1) D. Model 8832 - Double Door Garage 3 2 1 3 2 1 3 2 1 3 2 1 (2) (1) E. Model 8833 - Three Door Garage (1) (3) (2) 3 2 1 3 2 1 3 2 1 FIGURE 5 104388 B. If the operating distance drastically decreases, remove the battery access door See Fig. 1A, and replace the battery with a NEDA 1604, nine volt battery. C. Models 9921 and 9931: To activate your garage Door or Gate, simply depress your transmitter button until the door or gate starts to move. D. Models 8822, 8832 and 8833: To activate the desired Garage Door or Gate control, push either button ( 1) one, ( 2) two or ( 3) three, depending on which you desire to open or close. Channel one (1) is the left button. Channel (2) is the center button. Channel three (3) is the right button. MODELS MODEL 8822 & 8832 8833 STEP 3: INSTALL YOUR TRANSMITTER A. The transmitter can be either hand held or mounted on the sun visor with the enclosed visor clip. If sun visor mounting is desired attach the visor clip as shown. (See Fig. 5) If removal of the visor clip is necessary, place finger in loop at top of visor clip, and thumb on top edge of transmitter. Push down with thumb and pull up with index finger. Clip should release and pull out easily. ...

Dieses Handbuch ist für folgende Modelle:
Safety Gate - 8822 (169.36 kb)
Safety Gate - 9921 (169.36 kb)
Safety Gate - 9931 (169.36 kb)
Safety Gate - 8832 (169.36 kb)