Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
E
N
Aspect Ratio
Replacing the Bulb of the Dome Light
E
N
G
G
L
L
I
I
S
S
H
Press [A] (ASPECT) to change the aspect ratio as
Preparation:
H
follows.
≥ Turn the dome light switch off (page 46).
41
Default: NORMAL
42
≥ Open the display unit (page 50).
Mode: 4 types
NORMAL
1 Remove the 2 screws.
≥ The conventional display
A
image has a 4 to 3 ratio
A
2 Place your fi ngers at A (in 2 places) on the
of horizontal to vertical.
panel, and slowly pull down the panel.
≥ In this case, a blank area
2
remains on the right and
3 Pull out the bulb to be replaced.
left sides of the display.
≥ Do not turn the bulb but pull it straight out.
1
4 Push the new bulb into place.
FULL
≥ The screen is extended
5 Insert the end of the panel, and push it back into
horizontally as a whole
place as shown in the fi gure.
to the aspect of 16 to 9.
≥ The extension ratio is
6 Secure the screws.
the same at any point of
the screen.
Caution:
ZOOM
3
≥ Ask a qualifi ed specialist to do this job.
≥ The screen is fully
≥ While you are replacing a bulb, be absolutely
extended at the normal
sure to keep the dome light switch at OFF.
aspect ratio of 4 to 3.
Otherwise, you may burn yourself.
≥ The top and bottom of
≥ The bulb is very hot to the touch while it is
the screen are slightly
lighted and immediately after it has gone
[A] (ASPECT)
cut.
off. Before attempting to replace it, turn the
5
domelight switch off, wait several minutes
and then check that it cooled off.
JUST
≥ Use a bulb with the specifi ed ratings
≥ The screen is extended
(12 V/5 W). Do not use any other bulb.
horizontally to the aspect
≥ Gripping the bulb with too much force may
ratio of 16 to 9.
break it. Wear fi ngerstalls or use some other
≥ The extension ratio
anti-slip method when replacing it.
increases toward the
right and left ends of the
screen.
Note:
Note:
≥ Be careful not to scratch the surface of the front
≥ In some cases, the picture looks different from
cover when attaching it.
the original one due to your selection of aspect.
≥ This is to remind you that compression or
extension of the screen using the aspect ratio
changing function of this product for commercial
6
purpose of profi t making or viewing/listening
by the public could infringe on the rights of the
author protected by the copyright law.
≥ If you expand normal picture (4 to 3) by using
“JUST”, “ZOOM” or “FULL” aspect to the full of
the screen, you might not see the periphery of
the picture, or you might see a distorted picture.
Therefore, use the “NORMAL” mode to see the
original pictures as the author intended it.
84
CY-VHD9500U
CY-VHD9500U
85