Stimmen - 3, Durchschnittliche Bewertung: 4.7
(
)
)
|
Anleitung Zusammenfassung
DIGITAL AUDIO BUTTON 25. RESET BUTTON LOCATION OF PARTS AND CONTROLS 2 ПОДСОЕДИНЕНИЕ 4 ДИНАМИКОВ СТАНДАРТНЫЙ СОЕДИНИТЕЛЬНЫЙ ПРОВОД (ISO) 4 SPEAKER WIRING ISO CONNECTOR J В BACK UP(+) REAR RIGHT SP. I 2 | |1 | (-) (+) FRONT RIGHT SP. I 4 I I 4 | |3 | AUTOANT (+) (-) (+) FRONT LEFTSP. I 5 I I 6 | I 5 | GND B+ (-) (+) REAR LEFTSP. I 8 I |7 I I 8 | I 7 | (-) (+) СТОРОНАA 4: Желтый 5: Голубой 7: Красный 8: Черный SIDE А Yellow Blue Red Black СТОРОНА В 1: Фиолетовый 2: Фисгеговый/Чершй 3: Серый 4: Серый/Черный 5: Белый 6: Белый/Черный 7: Зеленый 8: Зеленый/Черный SIDE B 1. Violet 2. Violet/Black 3. Gray 4. Gray/Black 5. White 6. White/Black 7. Green 8. Green/Black LINE OUT - GREY: RED (R) WHITE (L) ПОДСОЕДИНЕНИЕ 2 ДИНАМИКОВ СТАНДАРТНЫЙ СОЕДИНИТЕЛЬНЫЙ ПРОВОД (ISO) 2 SPEAKER WIRING ISO CONNECTOR BACK UP(+) AUTOANT (+) GND B+ B FRONT RIGHT SP. (-) (+) FRONT LEFT SP. (-) (+) СТОРОНАA 4: Желтый 5: Голубой 7: Красный 8: Черный SIDEA Yellow Blue Red Black СТОРОНА В 3: Серый 4: Серый/ Черный 5: Белый 6: Белый/ Черный SIDE В 3: Gray 4: Gray/Black 5: White 6: White/Black 15 3620.фсс! 16.02.04 16:13 Раде 4 -о- РУССКИЙ СПЕЦИФИКАЦИИ РМ ДИАПАЗОН Частотный диапазон 65-108 МГц Промежуточная частота 10.7 МГц Предельная чувствительность менее 3 мкВ (сигнал/шум 30 дБ) Коэффициент подавления зеркальной частоты 45 дБ Коэффициент подавления помех 60 дБ на промежуточной частоте АМ ДИАПАЗОН Частотный диапазон Промежуточная частота Предельная чувствительность 522-1620 КГц 10.71 МГц 32 дБ ОБЩИЕ ХАРАКТЕРИСТИКИ Источник питания/Напряжение Чувствительность линейного выхода Сопротивление катушки динамика Максимальная выходная мощность Установочные размеры РС 12 В (с отрицательным заземлением на массу) 300 мВ ± 3 дБ 4 - 8 Ом 4x40 Вт (Макс.) Рама 178 х 50 х 156 мм Передняя часть 188 х 58 х 20 мм СРОК СЛУЖБЫ АВТОМАГНИТОЛЫ НЕ МЕНЕЕ 3-Х ЛЕТ 14 О ENGLISH INSTALLATION PRECAUTIONS • Choose the mounting location carefully so that the unit will not interfere with the normal driving functions of the driver. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight or hot air from the heater, or where it would be subject to dust, dirt or excessive vibration. • Use only the supplied mounting hardware for a safe and secure installation. • Be sure to remove the front panel before installing the unit. NOTE: Inclination angle for car radio installation must not exceed 30° otherwise the front panel will not open. Note: Keep the release key in the safe place as you may need it in future to remove the unit from the car. TO SUPPORT THE UNIT 1. UNIT 2. RELEASE CASE 3. HEX NUT 4. LOCKWASHER 5. PLAIN WASHER 6. CAR BODY 7. REAR SUPPORT STRAP 8. TAPPING SCREW 9. M5X 15 HEX BOLT 3620.qxd 16.02.04 16:13 Page 6 ~Q- ENGLISH USING THE REMOVABLE FRONT PANEL The front of the unit can be removed to prevent theft. 1. Press EJ/OPEN button (16) and the front panel will open. 2. Grip the release section and pull the front panel forward. Take care not to grip the tightly, or to drop the panel. 3. Close the inner cover. After detaching the front panel, be sure to close the inner cover to prevent dirt, dust or other foreign matter from entering the CD slot. 4. Keep the detached front panel in the protective case provided, front panel display. Note: Be sure not to drop the panel when detaching it from the unit. • Make sure that the front panel is the right way up when attaching it to the unit as it cannot be attached upside down. • Do not press the front panel hard against the unit when attaching it. It can be easily attached by pressing it lightly against the unit. • When you carry the front panel with you, put it in the supplied front panel case. • Do not press hard or give excessive pressure to the display window of the front panel when attaching it to the unit. 1. POWER ON/OFF (PWRVILLUMINATION CONTROL Press any key to power up the unit. Press this key for more than 1 second to turn off the unit. ILLUMINATION CONTROL: Press and release to increase display brightness in steps. 2. SELECT BUTTON: BASS/TREBLE/BALANCE/FADER (SEU Press to select the desired mode: VOLUME - BASS - TREBLE - BALANCE - FADER - VOLUME 3. VOL UP/VOL DOWN FOR BASS/TREBLE/BALANCE/FADER Rotating these key, you can adjust VOLUME, BASS, TREBLE, BALANCE and FADER. 4. PRESET STATIONS Six numbered preset buttons store and recall stations for each band. Storing a station: 1. Select a band (if needed). 2. Select a station. 3. Hold a preset button longer than one second. Preset station number appears in the display when station is saved. Recall a station: 1. Select a band (if needed). 2. Press a preset button for less than one second to select a previously stored station. 5. MUTE BUTTON (MUTE) Press this button to mute the sound. Audio will disappear. Press again to hear sound. 6. AUDIO DSP CONTROLS (EQ1 Press repeatedly to cycle through five mo...