Anleitung Kenwood, modell KDC-X959
2 Enter Audio Control mode Press the [AUD] button for at least 1 second. — 10 — 3 Select the Audio 3 Select the Audio Each time the button switch as shown below. 4 Adjust the Audio item Press the [ 4] or [ . ] button. Adjustment Item Display Range Bass Center Frequency Bass level "Bass FRQ" "Bass" 60/70/80/100 or 150 –8 — +8 (Hz) Bass Q Factor "Bass Q" 1.00/1.25/1.50/2.00 Bass Extend "Bass EXT" ON/OFF Middle Center "Middle FRQ" 0.5/1.0/1.5/2.0 (kHz) Frequency Middle level "Middle" –8 — +8 Middle Q Factor "Middle Q" 1.0/2.0 Treble Center "Treble FRQ" 10.0/12.5/15.0/17.5 (kHz) Frequency Treble level "Treble" –8 — +8 Balance "Balance" Left 15 — Right 15 Fader "Fader" Rear 15 — Front 15 Non-Fading level* "NF Level" –15 — +15 Front High Pass Filter "HPF Front" Through/40/60/80/100/120/ 150/180/220 (Hz) Rear High Pass Filter "HPF Rear" Through/40/60/80/100/120/ 150/180/220 (Hz) Non-Fading "LPF NF" 50/80/120/Through (Hz) Low Pass Filter* Non-Fading Phase* "NF Phase" Normal (0°)/Reverse (180°) Volume offset "Volume Offset" –8 — ±0 • According to the can be set in Bass Center Bass Q Factor Bass Center Frequency 1.00/1.25/1.50 60/70/80/100 2.00 60/70/80/150 • When the bass extend is set to extended by 20%. • Volume offset: Each source's volume can from the basic volume. • *: This mode is available only when (page 16) - Character information display: : (page 13) (page 16) "Display Type B" Character information display a Character information display b 1 Select the Display Type Press the [DISP] button. 2 Enter Display Control mode Press the [S.A] button. "Display Control" is displayed. 3 Switch character information display part b Press the [FM] or [AM] button. Switch character information display part c (Only when Display Type is "Display Type A") Press the [ 4] or [ . ] button. Each time the button is pressed the display switches. The Reference for the display content is after this operation's explanation. 4 Exit Display Control mode Display switching part for "Display Type A" and "Display Type B" When Display Type is set to "Display Type A" or "Display Type B", the displayed contents are changed. "Display Type A" Character information display part a Character information display part b Character information display part c Press the [S.A] button. Character information display part c cannot display the same information as character information display part b. — 13 — General General In Tuner source Character information b Display Information Display Station name "SNPS+FREQ" or Program Service name or Frequency Radio text "R-TEXT" Date & Clock "DATE+CLOCK" (Only when Display Type is "Display Type B") Date "DATE" Blank (Only when Display Type is "Display Type A") Frequency "Frequency" Character information display part c Display Information Display Spectrum Analyzer & Clock "S/ANA+CLOCK" Radio text "R-TEXT" Blank Date "DATE" Date & Clock "DATE+CLOCK" or "CLOCK" • The band display is always displayed on the a part display. • For Station name registration refer to (page 20). In CD/ External Character information b Display Information Display Disc name "DNPS" Disc title "DISC-TITLE" Track title "TRACK-TITLE" Date & Clock "DATE+CLOCK" (Only when Display Type i...
)
