Stimmen - 2, Durchschnittliche Bewertung: 3
(
)
)
|
Anleitung Zusammenfassung
Output (1 amp) Red / White P.B. Output (-) Purple / White VSS Output (Pulse) Orange / White Illum. Output (+) Green Reverse Output (+) White / Green SWC Output Radio Specific Steering Wheel Control Interface (Sold Separately) Program SWC Interface for Version 2. Installation Notes: For the most current and up-to-date application guide please visit 1. Vehicles with or without a factory amplifier: Connect the aftermarket radio’s front and rear speaker wires to the 16 pin plug. 2. The accessory output wire is located on the 11 pin CAN INTERFACE harness - connect this wire to the radio’s accessory wire. The accessory wire supplies +12v, 1 amp max when key is in the accessory or ignition position (see fig. 1: If more current is needed). Fig. 1 (using a SPDT relay) High Current 12v (Fused) 12v Acc. From Interface Diode 1N4005 or equivelant New High Current Output 3. 11 pin plug (to CAN INTERFACE): 1. White/Green - SWC output. 2. Green - Connect this wire to the radio’s reverse input wire only. 3. Orange/White - Connect this wire to the radio’s Illumination input wire only. 4. Violet/White - Connect this wire to the radio’s VSS input wire only. 5. Red/White - Connect this wire to the radio’s parking brake input wire only. Please Note: The parking brake wire will output a neg (-) trigger at all times until the vehicle is moving at a speed of approximately 3 mph or faster. - Note: Do not connect these wires to any circuit other than the aftermarket radio's wire harness. 4. 11 pin plug (to SWC INTERFACE): This is a quick connection to a radio specific SWC interface. No additional connections are necessary other than radio control connections. Plug the radio specific SWC interface in to this connector and program the radio specific SWC interface for version 2. Do not cut the loops. Refer to the SWC interface instruction manual for the radio specific control function programming order. 5. Refer to the aftermarket radio’s instruction manual for testing VSS, Reverse, Parking Brake and Illumination outputs. Ground DISCLAIMER: Under no circumstances shall the manufacturer or the distributors of the C2R-VW2 be held liable for consequential damages sustained in connection with the C2R-VW2. The manufacture and it’s distributors will not, nor will they authorize any representative or any other individual to assume obligation or liability in relation to the C2R-VW2 other than its replacement. 01-04-10 Pacific Accessory Corporation - Santa Ana, CA 92705 techsupport@pac-audio.com • Voice: 866-931-8021 • Fax: 714-835-3233 • www.pac-audio.com...