1124320 Assembly, Installation and Operating Instructions Yes, you can: _SAVE THESE INSTRUCTIONS_ NOTE: Check ALL parts for shipping damage. In case of shipping damage, DO NOT use. Contact Carrier/Dealer for further instruction. SAFETY SUMMARY To ensure the safe installation, operation and use of the MPR Leg Extension Kit, these instructions MUST be followed: GENERAL WARNING DO NOT install or use this equipment without first reading and understanding these instructions. If you are unable

Die funf Schlitze der Vlieswand mussen zum Sitz des Wagens hin ausgerichtet sein. 2. Befestigen Sie die kurzen schwarzen Gurte, die sich am oberen Ende des Vlieses befinden, an dem oberen Querrahmen des Wagens. 3. Fuhren Sie den jeweiligen Gurt von unten durch die Kunststoff-Schnalle auf sich zu. Falten Sie den Gurt, fuhren Sie ihn durch die Schnalle zuruck und ziehen Sie den Gurt fest. Siehe nebenstehende Abbildung. 4. Fuhren Sie den am Sitz befestigten Schrittgurt durch den horizontalen Schlit

The XtraComfort seat uses a shape-molded EVA foam ultra-plush seat pad and backrest up to 3” thick. Its “progressive cushioning effect” makes the seat soft at first, then gradually more supportive - perfect for longer paddling adventures. The backrest is adjustable fore and aft and up and down. The angle of the seat pan is also adjustable, while maintaining a low center of gravity. Finally, the seat is made from a moisture resistant material to help keep you dry and comfortable while paddling.

Kompernaß GmbH Burgstraße 21 D-44867 Bochum (Germany) CAR SEAT MASSAGER KH4105 ob CAR SEAT MASSAGER (1Г) Operation and Safety Notes G Cob) Before reading, unfold the page containing the illustrations and familiarise yourself with all functions CID of the device. (CY) - GB/IE/CY Operation and Safety Notes Page ?

DO NOT operate mower without seat retention bolts properly tightened. 4. Close upper body and push retention latch (P/N 3934) over transaxle backing plate. BODY REMOVAL 1. The 304 has a (2) piece polyethelene body. The upper body can be folded forward to expose the transaxle. In some cases, it may be necessary to remove the upper body to service the transaxle. 2. To remove upper body, remove two bolts (P/N 3080) from the front of upper body hinge located on the brake shaft (P/N 9283). Disc

Repeat for other legs * Booster Seat can be used without adjusting height. Rubber pads on bottom of bag provide a non-slip grip (C). Figure 1 Adjusting the Height of the Booster Seat* A. B. 1. Unbuckle seat-back, seat-bottom and shoulder straps from under the chair to remove Travel Booster Seat from chair 2. Tuck seat-back strap, seat-bottom strap and safety seat belt into top flap, and secure front flap into place 3. If adjustable height was used, turn seat over. Pull adjustable leg up, rotate

NEVER remove the spring steel keeper. Doing so may cause the load to disconnect from the hook, resulting in property damage and personal injury. 6. ALWAYS thoroughly inspect each component of the towing/winching assembly for damage or any unsafe condition before attaching a load. If you are in doubt about the safe operation of any of these devices, DO NOT use them. 7. If you do not have experience towing/ winching loads with your vehicle, WE STRONGLY RECOMMEND that you read books or get profes

The base can remain in the vehicle during visual inspection of carrier. Turn carrier upside down so the underside of the carrier faces upward. If one or both tabs do not fully cover the opening, contact Britax Child Safety, Inc. at 888-427-4829 for further instruction. If both tabs are not fully covered, you may continue to use the carrier in vehicle without the base. On bottom of carrier where rubber strips run along edges of support rails, there is an exposed opening with attachment hooks.

WARNING! DEATH OR SERIOUS INJURY CAN OCCUR: • Model #2000 is for use only with individuals who weight between 20 - 102 lbs (9.09 - 46.36 kg) and whose shoulder height when sitting is 12 -20 in. • Model #2500 is for use only with individuals who weight between 50 - 130 lbs (29.5 - 59 kg) and whose shoulder height when sitting is 13 -24 in. • Model #2500 - Do not use with individuals under 65 lbs (29.5 kg). • Failure to follow each of the following instructions can result in your child striking th

STEP 5: Head Pads and Lateral Positioning Pads The head pads may be adjusted for height. Located behind, and underneath each head pad is a plastic ball, attached to the lace that passes through the head pad. Squeeze the button on each ball and slide the ball up or down to change the height of the head pads. Lateral Positioning Pads: If the occupant is slender or small, the car seat may be too wide. You can narrow the inside seat width with this Lateral Positioning Pad Set. Use only as many pads