Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Anleitung Zusammenfassung
Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. 2009 © Koninklijke Philips Electronics N.V. All rights reser ved. Specifications are subject to change without notice. Trademarks are the proper ty of Koninklijke Philips Electronics N.V. or their respective owners. Philips reser ves the right to change products at any time without being obliged to adjust earlier supplies accordingly. Your car power subwoofer Congratulations on your purchase, and welcome to Philips! To fully benefit from the suppor t that Philips offers, register your product at Introduction With the subwoofer, you can enjoy high quality sound per formance with power ful bass and beats. What’s in the box A Check and identify the contents of your package: a Subwoofer b Screw_4x50mm (x10) c Frame 2. Installation A depth of at least 124mm is required to mount the subwoofer. Measure the depth of the area where you are to mount the subwoofer, and ensure that the subwoofer does not obstruct any other components of the car. Option 1: Mount on rear tray B You can mount the subwoofer on the rear tray. a 1 Turn off the car ignition key. • If the power is on, the click noise generated by the connection may damage the speakers. 2 Paste the supplied template onto the location for mounting the subwoofer. 3 Mark the cut-off hole and the 10 bolt holes. b 4 Cut out the marked areaa and drill the bolt holes. c 5 Connect the subwoofer to the amplifier. d 6 Mount the subwoofer into the rear tray with the supplied screws. e Option 2: Install in a sealed enclosure C If the subwoofer cannot be mounted on the car, place it in a sealed enclosure. a 1 Make a sealed enclosure in dimension as below: The box: CSP1000 CSP1200 Height 338mm 358mm Length 522mm 568mm Width 232mm 238mm The mounting hole: CSP1000 CSP1200 Mounting hole diameter (Outside) 257.3mm 307mm Mounting hole diameter (Inside) 231.9mm 283.7mm Screw hole diameter 3.3mm 3.3mm 2 Connect the subwoofer to the amplifier (see step 5 of “Option 1: Mount on rear tray” section). 3 Install the subwoofer into the sealed enclosure with the supplied screws. b 3. Product information Note • Product information is subject to change without prior notice. Model CSP1000 CSP1200 Speaker type 25cm subwoofer 30cm subwoofer RMS power (Watts) 250W 400W Peak music power (Watts) 1000W 1600W Sensitivity (dB/W/m) 88dB 89dB Frequency response (Hz) 25-1000Hz 20-1500Hz Impedance (ohms) 4 ohms 4 ohms Magnet mass (Oz) 55.4Oz 55.4Oz Mounting depth (mm) 124mm 146mm 4.Troubleshooting To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, go to the Philips web site (When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available. © 2009 Koninklijke Philips Electronics N.V. All rights reserved. CSP1000...
Dieses Handbuch ist für folgende Modelle:Car Audio - CSP1200/51 (608.82 kb)