Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Anleitung Zusammenfassung
7 Troubleshooting
8 Notice
Warning
Any changes or modifications made to this
device that are not expressly approved by
• Never remove the casing of this device.
WOOX Innovations may void the user’s
authority to operate the equipment.
To keep the warranty valid, never try to repair
This Class B digital apparatus complies with
the system yourself.
Canadian ICES-003.
If you encounter problems when using this
This device complies with Part 15 of the FCC
device, check the following points before
Rules. Operation is subject to the following two
requesting service. If the problem remains
conditions:
unsolved, go to the Philips Web page
• This device may not cause harmful
(www.philips.com/support). When you contact
interference, and
the Consumer Care, make sure that the
• This device must accept any
product is nearby and the model number and
interference received, including
serial number are available.
interference that may cause undesired
operation.
No power
This equipment has been tested and found
• Ensure that the AC power plug of the unit
to comply with the limits for a Class B digital
is connected properly.
device, pursuant to part 15 of the FCC Rules.
• Ensure that there is power at the AC
These limits are designed to provide reasonable
outlet.
protection against harmful interference in a
No sound
residential installation. This equipment generates,
• Adjust the volume.
uses, and can radiate radio frequency energy
and, if not installed and used in accordance
Poor radio reception
with the instruction manual, may cause harmful
• Increase the distance between the unit and
interference to radio communications.
your TV or VCR.
However, there is no guarantee that
• Fully extend the FM antenna.
interference will not occur in a particular
Alarm does not work
installation. If this equipment does cause harmful
• Set the clock/alarm correctly.
interference to radio or television reception,
which can be determined by turning the
Clock/alarm setting erased
equipment off and on, the user is encouraged
• Power has been interrupted or the power
to try to correct the interference by one or
plug has been disconnected.
more of the following measures:
• Reset the clock/alarm.
• Relocate the receiving antenna.
• Increase the separation between
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
12
...Dieses Handbuch ist für folgende Modelle:
Car Audio - ORD2100C/37 (1.11 mb)