Stimmen - 5, Durchschnittliche Bewertung: 3.8
(
)
)
|
Anleitung Zusammenfassung
When an iPod is syncing, DO NOT undock your iPod OR press the Sync Button Changing the Speaker Panels The iH64 comes with 3 pairs of detachable speaker panels (one is already installed). 1. Pull out the speaker panel from speaker to remove the speaker panel. 2. To replace the speaker panel into the speaker, simply line up the panel and press firmly into place. Make sure the panel is placed properly so it does not vibrate. Operating the Remote On/Off Switch To save battery power, switch the Remote On/Off Switch on the bottom of the main unit to Remote Off. Doing so disables the remote control. The switch will not function while using the AC adaptor. remote off remote on Remote On/Off Switch 4 5 Using the Optional Remote Control The remote control battery is already installed at the factory. When the remote control stops operating or its range seems reduced, it is time to replace the battery with a new one. 1. The battery compartment is located on the back end of the unit. 2. Slide the battery compartment door to release the battery door. 3. Remove the old battery and insert a new CR2032 battery, checking that the + and – sides of the battery match the drawing on the battery door. 4. Replace the battery door on the remote control. Note: Make sure you dispose of batteries properly (see your local regulations). Battery Compartment Pressing FWD/REV while iPod is inserted will FWD/REV to next/previous track Pressing and holding FWD/REV while iPod is docked will scan forward/reverse within currently playing track. Pressing Play/Pause from power off mode will play iPod. Pressing Play/Pause while iPod is docked and playing will pause iPod. Pressing the up/down buttons for Bass and Treble, will raise or lower bass or treble Power Button turns unit ON and OFF Pressing the mute button will mute unit. While unit is muted, LED will flash as long as unit is muted. Pressing mute again or pressing volume up or down will unmute. The up, down, fwd, rev, menu, and enter buttons are used to navigate the iPod. The shuffle and repeat buttons will activate/deactivate the iPod’s shuffle and repeat modes. Remote not included with all iH64 models. To order a remote, please visit Volume Buttons raise and lower volume on the unit. Press again to resume play. Install/Replace the Remote Control Battery Pressing the SRS WOW button will toggle the SRS WOW sound enhancement effect on and off. Pressing the reset button will reset Bass and Treble level to 0 and turn SRS WOW sound effect on. ........ A Consumer Guide to Product Safety A Consumer Guide to Product Safety When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1. Water and Moisture – The unit should not be used near water. For example: near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. 2. Ventilation – The unit should be situated so that its location or position does not interfere with its proper ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface that may block ventilation openings. Also, it should not be placed in a built-in installation, such as a bookcase or cabinet, which may impede the flow of air through the ventilation openings. 3. Heat – The unit should be situated away from heat sources such as radiators, heat registers, stoves or other appliances (including amplifiers) that produce heat. 4. Power Sources – The unit should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. 5. Power-Cable Protection – Power supply cables should be routed so that they are not likely to be walked on or pinched by items placed upon or against them. It is always best to have a clear area from where the cable exits the unit to where it is plugged into an AC socket. 6. Cleaning – The unit should be cleaned only as recommended. See the Maintenance section of this manual for cleaning instructions. 7. Objects and Liquid Entry – Care should be taken so that objects do not fall and liquids are not spilled into any openings or vents located on the product. 8. Attachments – Do not use attachments not recommended by the product manufacturer. 9. Lightning and Power Surge Protection – Unplug the unit from the wall socket and disconnect the antenna or cable system during a lightning storm or when it is left unattended and unused for long periods of time. This will prevent damage to the product due to lightning and power-line surges. 10. Overloading – Do not overload wall sockets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electric shock. 11....