Stimmen - 0, Durchschnittliche Bewertung: 0
(
)
)
|
Dieses Gerät hat auch andere Anweisungen:
Anleitung Zusammenfassung
Better surround effect will result if all speakers are set at the same distance from the listening position. Place the front speakers at a suitable distance to the left and right of the television. Place the subwoofer (not supplied) on either side of the television. Place the center speaker on the top-center of the TV set. The placement of surround speakers greatly depends on the configuration of the room. Locating the speakers as a 6.1 channel speaker system (C-1) Locating the speakers as a 5.1 channel speaker system (C-2) The surround speakers may be placed on both sides of the listening position A or behind the listening position B. Note Be sure to place the speaker in a flat, horizontal place. Setting the center speaker (D) To put the center speaker on your TV set, attach a foot pads (supplied) to each bottom corner of the speaker, and make sure that the speaker is completely flat on top of the TV. Setting the surround and surround back speakers To install the surround and surround back speakers on a wall, follow the steps below. 1 Prepare screws (not supplied) that are suitable for the hole on the back of each speaker (E). 2 Fasten the screws to the wall. The screws should protrude 5 to 7 mm (F). 3 Hang the surround and surround back speakers on the screws (G). Notes • Use screws that are suitable for the wall material and strength. As a plaster board wall is especially fragile, attach the screws securely to a beam and fasten them to the wall. Install the surround and surround back speakers on a vertical and flat wall where reinforcement is applied. • Contact a screw shop or installer regarding the wall material or screws to be used. • Sony is not responsible for accident or damage caused by improper installation, insufficient wall strength or improper screw installation, natural calamity, etc. Troubleshooting Should you encounter a problem with your speaker system, check the following list and take the indicated measures. If the problem persists, consult your nearest Sony dealer. There is no sound from the speaker system. •Make sure all the connections have been correctly made. •Make sure the volume on the amplifi er has been turned up properly. •Make sure the program source selector on the amplifier is set to the proper source. •Check if headphones are connected. If they are, disconnect them. There is hum or noise in the speaker output. •Make sure all the connections have been correctly made. •Make sure none of the audio components are positioned too close to the TV set. The sound has suddenly stopped. •Make sure all the connections have been correctly made. Contact between bare speaker wires at the speaker terminals may cause a short-circuit. Specifi cations SS-MFS500H (Front speakers) Speaker system 2-way, magnetically shielded Loud speaker units Woofer: 10 cm, cone type . 2 Tweeter: 2.5 cm, balanced dome type Enclosure type Bass refl ex Rated impedance 8 ohms Power handling capacity Maximum input power: 120 watts Sensitivity level 85 dB (1 W, 1 m ) Frequency range 50 Hz - 50,000 Hz Dimensions (w/h/d) Approx. 232 . 985 . 270 mm including front grille Mass Approx. 8.0 kg SS-CN250 (Center speaker) Speaker system Full range, magnetically shielded Speaker units 10 cm, cone type . 2 Enclosure type Bass refl ex Setting the amplifi er Rated impedance 8 ohms Power handling capacity Maximum input power: When connecting to an amplifier with internal multi 100 watts channel decoders (Dolby Digital*1, DTS*2, etc.), you Sensitivity level 88 dB (1 W, 1 m) should use the setup menus for the amplifier to specify Frequency range 85 Hz - 20,000 Hz the parameters of your speaker system. Dimensions (w/h/d) Approx. 355 . 130 . 144 mm The setup menus for the amplifier differ depending on including front grill whether or not a subwoofer (not supplied) is used. Mass Approx. 2.6 kg See the table below for the proper settings. For details on the setting procedure, refer to the manual that was provided with your amplifi er. SS-SR250 (Surround and surround back speakers) Speaker setup (Subwoofer is used) Speaker system Full range For Set to Speaker unit 10 cm, cone type Front speakers LARGE*3 or SMALL Enclosure type Bass refl ex Rated impedance 8 ohms Center speaker SMALL Power handling capacity Maximum input power: Surround speakers SMALL 100 watts Subwoofer (Not supplied) ON (or YES) Sensitivity level 85 dB (1 W, 1 m) Frequency range 85 Hz - 20,000 Hz Dimensions (w/h/d) Approx. 180 . 130 . 146 mm including front grill Speaker setup (Subwoofer is not used) Mass Approx. 1.4 kg Surround back SMALL*4 For Set to Supplied accessories Front speakers LARGE Speaker cord 2.5 m (3) Center speaker SMALL Speaker cord 10 m (3) Surround speakers SMALL Foot pads (4) Subwoofer (Not supplied) OFF (or NO) Design and specifications are subject to change without Surround back SMALL*4 notice. *1 “Dolby” and the dou ble-D symbol are trade marks of Dolby Laboratories. *2 “DTS” and “DTS Digital Surround” are registered trademarks of Digital Theater...