Stimmen - 4, Durchschnittliche Bewertung: 3.5
(
)
)
|
Anleitung Zusammenfassung
The display will change from time to radio frequency. Set the BAND selector to the desired band, AM or FM Auto. Rotate the TUNING control until the display shows the desired AM or FM station frequency, Turn theTUNiNG control clockwise to select higher numbered frequencies or counter-clockwise to select lower numbered frequencies. The FM STEREO indicator will light when you tune to an FM Stereo station. Rotate the VOLUME control to increase or decrease the volume level. If you want to increase the bass response set the DBBS button to the ’On’ -«-positon. Note: If you are listening to music that contains heavy bass at high volume levels the sound may become distorted if the DBBS switch is set to the 'On'--- position. If this occurs set the DBBS switch to the ‘Off position, or reduce the volume level. When you are finished listening set the POWER button to the 'Off A position. The display changes from radio frequency to correct time and the display lighting goes off. 9 OPERATING INSTRUCTIONS (CONTINUED) Docking and Charging Your iPod® This system is designed with the same 30-pin connector found in al! iPod0 docks. By simply connecting your iPod® to the docking station on the front pane! of this system you can play your iPod® through the speakers of this system. And you can also recharge the battery in your iPod0. Note: Recharging is only possible when you are using the system with the included AC adapter, Your iPod® battery will not be recharged when you are operating this system on battery power. To accommodate all models of dockable iPod® we have included four different adapter/ inserts to ensure that your iPod® will fit properly in the docking station. Refer to the chart below to select the proper adapter / insert for your particular model of dockable iPod®. Note; If you have a earlier non-dockable iPod® , or an iPod® Shuffle, please refer to the next section to connect you device to the Auxiliary Input jack. iPod® inserts Your unit comes with 4 removable inserts to ensure your iPod® fits properly in the dock on the front of the system. iPad® version L t' y J , 4f] i ! q !“ O •*! J fc ni ._ •' J 11 J O - ! j j - fa JO iPod* size 20 GB 4(5 G8 10 15 G 8 GB 3U G9 20 30 4a €0 GB CQ CSV GB 2 4 GB GB 30 GC tiO GO A—<^=29 A A A A A A 8 0 ft u K C c 0 1. Place the proper adapter I insert into the docking station. The iPod® 30-pin connector should fit through the opening in the bottom of the insert. 2. Gently press the insert into the dock until it is properly seated. 3. With your iPod® in the Power 'Off mode carefully place it into the insert. Note: Remove any accessory case or "skin'' from your iPod® before inserting it in the dock. 4. To remove or replace an insert, first remove your iPod0 from the dock, then grip the insert and gently lift it upward and out of the dock. 10 OPERATING INSTRUCTIONS(CONTINUED) Playing your iPod® Important To prevent distortion during iPod® playback you should go to the IVlain Menu of your iPod® , select the Settings Menu page, select the EQ Setting, and make sure that the EQ function is set to "Off". (Main Menu —> Settings Menu —) EQ Setting •—> Select "Off” ) ID 6 ell № CT^I n After inserting your iPod® in the dock as described above, set the POWER switch of this system to the 'On' position, and the FUNCTION switch to the iPod® position. If necessary, release the HOLD switch on your iPod® and turn it on. Select the song or album that you wish to play on your iPod® using the click-wheel navigation controls as usual. Use the VOLUME control on this system to increase or decrease the speaker volume level. The volume control on your iPod® has no effect on the speaker volume level. When you are finished listening press the POWER button to turn this system 'Off'. The display lighting will turn off. If you are using the AC adapter, the charging indicator will appear on your iPod0 display Important Note To prevent damage to your iPod® we recommend that you do not play your iPod® when you are carrying this system around as a portable. The system should be placed in a stable, secure position before connecting and operating your iPod® . 11 OPERATING INSTRUCTIONS(CONTINUED) Listening To A Non-Docking iPod® Or Other Portable Music Player Some early iPod® models and the iPod® Shuffle do not include (he 30-pin docking connector found on most other iPods®. We have provided an Auxiliary Input Jack on (he back panel of this system and included a stereo connection cable so that you can still connect non-docking iPods®, other MP3 players, or personal CD players to this system. KB a9* Locate the stereo connection cable supplied with this system. Connect one end of the 3.5mm stereo cable into the auxiliary input jack (AUX) located on the back of the unit, and other end to the headphone or line out jack on your portable audio device. Set the POWER button to the 'On' position and (he ...
Dieses Handbuch ist für folgende Modelle:Lautsprecher und Subwoofer - ITONE IP100C (448.95 kb)